Parts for your 2008 Honda Cr-v-Exhaust gasket

2008 Honda CR‑V exhaust gasket — what it is, where it lives, and when to replace it

Yes, the 2008 Honda CR‑V uses exhaust gaskets. Honda’s 2007–2011 CR‑V Service Manual (Exhaust System) and the Honda Electronic Parts Catalogue list multiple sealing gaskets: a multi‑layer steel gasket between the cylinder head and the exhaust manifold, a spring‑loaded “donut” gasket between the manifold/catalyst and the front pipe, and flat/flange gaskets further rearward. Major aftermarket catalogues for this model (e.g., Walker, Fel‑Pro) also specify these gaskets, confirming fitment on the K24‑series engine used in 2008 CR‑V models.

The exhaust gasket’s job is to keep hot gases inside the system, cut down on noise, and protect the cabin from fumes. On the 2008 CR‑V, the manifold gasket is a stainless multi‑layer type that copes with heat cycles and expansion at the head. The spring‑joint “donut” is a crush ring that lets the front pipe move slightly without leaking, handy for bumps and thermal movement. Further back, flat/flange gaskets keep the mid‑pipe and muffler joints sealed so the O2 sensors get clean readings and the cat can do its thing properly.

There’s no fixed replacement interval in Honda’s service literature, but best practice is to renew any exhaust gasket once a joint has been undone, or whenever there’s a leak. Signs a CR‑V exhaust gasket is on the way out include:

• A ticking or hissing sound that’s louder on cold start or under load
• Whiffs of exhaust or a sulphur smell around the engine bay or underbody
• Sooty/black deposits at a flange or spring joint
• Check Engine Light with fuel‑trim or O2 sensor codes from false air

Servicing tips for the 2008 CR‑V exhaust gaskets:

• Always fit new gaskets when refitting the manifold, cat, front pipe, or muffler. Reusing a crushed donut usually ends in a leak.
• Use new spring bolts and keepers at the front pipe joint