Your Selected Vehicle
Parts for your 2008 Holden Captiva 7-Batteries
LED Autolamps 12V Sequential Indicator Strip Light 10 Square LEDS Amber Lens Blister Pack - 235ASEQ-2
LED Autolamps 12V Slimline/Low Profile Reverse Lamp with Black End Caps - 285BW12
LEDAUT 12V Stop/Tail/Indicator/Reverse Light 275x100mm Blister Pack - 275ARW
LED Autolamps 355 Series Multi Volt Black Stop/Tail/Indicator/Reverse/Reflector LHS & RHS Twin Blister Pack - 355BARWM-2
LED Autolamps 12/24V LED Stop/Tail/Indicator/Reflector Light 28cm Cable Blister Pack - 275MAR
Explore 4WD & Adventure
LED Autolamps Tray Conversion Kit To suits Hilux Contains Two Cables - PATCH-HILUX
LED Autolamps 174 Series Reverse Lamp 12/24V, Surface Mount, 40cm Cable - 174WMB
LED Autolamps 174 Series Stop/Tail/Indicator Lamp 12/24V, Surface Mount, 40cm Cable - 174ARMB
LED Autolamps Front Indicator & Position Light LED 24V Surface Mount - 135CAT124
LED Autolamps 12V Stop/Tail/Ind/Rev LED Light Kit 450mm Loom DT04 Connector - SO282ARWM2LR450
LED Autolamps 385 Series Rear Combination Lamp LHS with 7 core plug - 385ARWMLCSB
LED Autolamps Multi Volt Round Indicator Lamp With Amber Lens Recessed Mount - 102AM
LED Autolamps Multi Volt Stop/Tail/Indicator Lamp With Reflex Reflectors Grey Base Blister Pack 1 pce - 100ARM
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Lamp With Inbuild Reflectors - 283ARWM
LED Autolamps 12/24V Stop/Tail/Indicator/Reflector With Licence Plate Lamp - 99ARLM
LED Autolamps Multi Volt Amber LED Side Marker 3 SMD LEDs Blister Pack - 181AME
LED Autolamps 174 Series Stop/Tail Lamp 12/24V, Surface Mount, 40cm Cable - 174RMB
LED Autolamps 10/30V LED Side Direction Indicator Light With 3m Tinned Cable - 58AM3
LED Autolamps 12V Front Indicator/Marker Lamp 80mm Round Blister Pack - 80AW
LED Autolamps Twin Function Side Indicator with Red Amber Side Marker RHS Multivolt - 800ARIMR
LED Autolamps Twin function rear position with supplementary rear indicator - 97CRIMCSB
LED Autolamps Multi Volt Reverse Lamp With 35 SMDS Blister Pack With Black Base - 135WM
LED Autolamps Multi Volt Stop/Tail/Indicator Lamp Black Bracket With 40cm Wire - 80BSTIM
LED Autolamps 9/30V LED Red Amber Side Marker Light Clear Lens 30cm Wire - 35ARMB
LED Autolamps 12/24V LED Stop/Tail/Indicator Lamp With Reflex Reflector Blister Pack 1 pce - 150ARM
2008 Holden Captiva 7 Batteries: What They Do and How to Look After Them
Per the 2008 Holden Captiva CG Owner’s Handbook and GM service information for the Captiva/Antara platform, this model is fitted with a 12‑volt lead‑acid starting battery. Major battery catalogues used in Australia and New Zealand (e.g., ACDelco and Bosch ANZ application guides) list DIN66/LN3 (H6) style replacements for the 2008 Captiva 7, confirming battery fitment and specs commonly around 600–750 CCA depending on engine.
On this Captiva 7, the battery cranks the engine, stabilises voltage for the ECU, BCM, ABS/ESC and SRS, and keeps accessories like lights, infotainment and central locking behaving when the alternator isn’t spinning. It’s a hard‑working bit of kit, especially on short, stop‑start runs or in hot Aussie and Kiwi summers.
For replacement, choosing a quality maintenance‑free calcium or AGM (where specified) 12 V battery with the correct footprint (DIN66/LN3/H6), terminal layout and at least the OE‑equivalent cold‑cranking amps is the go. Petrol variants typically suit 600–680 CCA, diesels benefit from higher CCA (often 700+). Always match what’s on the under‑bonnet label or owner’s handbook.
Good servicing habits keep the Captiva’s electrics happy and starting crisp:
- Load‑test annually from year three, or sooner if cranking slows.
- Check and clean terminals, ensure clamps are snug and corrosion‑free.
- Verify the charging system is healthy (about 13.8–14.7 V with engine running, lights on).
- Use a memory saver when swapping batteries to preserve radio presets and module settings.
- When jump‑starting, connect the negative lead to a solid engine/chassis earth, not the battery’s negative post.
Expect 3–5 years of service life, influenced by climate and driving. Lots of short trips can undercharge the battery, a smart charger top‑up overnight every month or two helps. After replacement, some Captivas may need a window auto‑up/down relearn and clock reset, technicians will also clear any low‑voltage fault memories if needed.
Recycling matters—hand the old unit to a parts store or workshop for proper disposal. Keeping the battery in spec protects sensitive electronics and ensures the Captiva 7 is ready to go when the family is.
Popular questions about 2008 Holden Captiva 7 batteries
What battery size and CCA should a 2008 Captiva 7 use?
Most 2008 Captiva 7 models take a DIN66/LN3 (H6) case with 12 V and around 600–750 CCA. Petrol engines are fine near 600–680 CCA, while diesels prefer higher CCA for cold cranking. Always confirm the terminal layout and spec against the owner’s handbook or the label under the bonnet.
How long will the battery last, and what short trips do to it?
Typically 3–5 years. Heat, vibration and frequent short runs shorten life by leaving the battery undercharged. If the Captiva mostly does school runs and errands, a periodic maintenance charge with a smart charger can add years.
Does a 2008 Captiva 7 need coding after battery replacement?
There’s no complex battery “coding” like some Euro start/stop cars, but using a memory saver is wise. Expect to reset the clock and radio presets, and sometimes relearn the window one‑touch function. A workshop can also clear any low‑voltage fault memories if warning lights linger.