Parts for your 2008 Ford Transit-Brake shoes

2008 Ford Transit brake shoes — what they are and when they’re needed

Based on Ford’s Workshop Manual for Transit 2006–2013 (Section 206-02), the Haynes Ford Transit Diesel 2000–2013 manual (No. 4808), and Ford ETIS/Microcat parts catalogues for V347/V348 models, the 2008 Ford Transit commonly uses rear drum brakes with brake shoes on many variants (especially RWD). Front brakes are discs across the range. Some FWD and specific GVW/optioned models were built with rear disc brakes instead, in which case there are no brake shoes. So, brake shoes are relevant to most 2008 Transits, but checking the VIN/axle spec or a quick look behind the rear wheels will confirm what’s fitted.

Where fitted, the Transit’s rear brake shoes are the curved friction linings that press outwards against the inside of the drum to slow and stop the van. They also do the heavy lifting for the handbrake, which clamps the shoes mechanically to hold the vehicle when parked. Inside the drum, the wheel cylinder pushes the shoes, return springs pull them back, and a self-adjuster keeps the clearance in check as the linings wear. For trades, courier work, and stop–start city runs, the shoes can see plenty of heat and dust, so good servicing pays off.

As part of routine servicing, it’s smart to inspect the rear drums and shoes annually or about every 20,000 kilometres. Look for even wear, glazing, heat spotting, cracked linings, or any sign of brake fluid on the shoes or backing plate (a hint the wheel cylinder is weeping). Clean with proper brake cleaner—don’t blow out dust. Lubricate the shoe contact points on the backing plate sparingly with high‑temp brake grease, and make sure the self‑adjuster moves freely.

• Replace shoes as an axle pair and bed them in with gentle, repeated stops over the first 200–300 km.
• Consider a fitting kit (springs, hold‑down pins, and adjusters) so everything returns and adjusts properly.
• Inspect drums and measure for wear/out‑of‑round