Parts for your 2008 Ford Fiesta-Manifold gasket

2008 Ford Fiesta manifold gasket — what it does and when to replace it

Yes, a manifold gasket is absolutely used on the 2008 Ford Fiesta. Technical sources such as the Ford Workshop Manual for WS/WQ Fiesta (engine section 303), the Motorcraft/Ford service parts catalogue, and widely used trade databases like Autodata/Haynes all specify dedicated intake manifold gaskets and exhaust manifold gaskets for these models. The Ford procedures also call for renewing the gasket any time the manifold is removed, which confirms it’s a fitted, serviceable part on the vehicle.

On the 2008 Fiesta, there are two main types: the intake manifold gasket (often an O-ring style set on the plastic intake) and the exhaust manifold gasket (usually multi-layer steel or composite). Their job is to seal the manifolds to the cylinder head so nothing unwanted sneaks in or out—no unmetered air into the intake, and no hot exhaust gases leaking to atmosphere. A healthy seal keeps idle smooth, trims stable, power on tap, emissions tidy, and noise down.

There’s no fixed replacement interval, but both gaskets should be renewed whenever the related manifold is removed. They’re also replaced if there are leak signs. For the intake side, look for rough idle, a hissing sound, lean codes (like P0171), or higher than normal fuel trims. For the exhaust side, signs include a ticking noise on cold start, exhaust odour in the bay, sooty marks around the flange, or an oxygen-sensor fault from false air.

• Good practice when replacing: use quality gaskets, clean mating faces carefully, follow the Ford torque sequence and specs, and don’t add sealant unless the workshop manual specifically instructs it.
• Expect more effort on the exhaust side due to heat cycles and stubborn studs/nuts