Parts for your 2007 Toyota Wish-Gas struts

2007 Toyota Wish gas struts — what they do and when to replace them

Based on Toyota’s Electronic Parts Catalogue for the ANE10/ZNE10 series (2003–2009) and the Toyota repair manual procedures for “Back Door Stay — Removal/Installation”, the 2007 Toyota Wish is fitted with gas-charged struts on the rear hatch. Reputable aftermarket catalogues from brands like Stabilus and Monroe also list dedicated gas springs for the 2003–2009 Wish, confirming fitment.

On the 2007 Toyota Wish, the rear hatch gas struts do the heavy lifting — literally. They counterbalance the weight of the back door, control how smoothly it opens, and hold it safely at full height so no one cops a surprise bump on the head. Inside each unit is pressurised nitrogen and a small amount of oil, over time, seals wear, pressure drops, and performance tails off.

There’s no fixed service interval for gas struts, but they’re worth a look at every service. If the hatch feels heavier, opens sluggishly, won’t stay up in cool weather, or needs a helping hand, the struts are on the way out. Most OE-style units last many years, but climate and use (lots of short trips and frequent opening) can shorten their life.

• Signs they’re tired: hatch drops or won’t hold, jerky motion, oily residue on the shaft, or a “whoosh” that’s gone quiet.
• Care tips: keep the exposed shafts clean, don’t grab them with tools or spray petroleum-based lubes on them, avoid loading the open hatch with extra weight.
• Safety first: support the hatch with a prop or helper before removing a strut. Never rely on a weak strut to hold the door up.

When replacement time comes, it’s smart to swap the pair together so lift and balance match left to right. Orientation matters — the fat body typically faces up at the body side to keep the internal seal lubricated. Clip-on ball sockets make the job straightforward, but take care not to twist the shaft. Tighten mountings to manufacturer spec and check smooth operation a few times before calling it done.

Worth noting for anyone hunting bonnet parts: the 2007 Wish uses a prop rod on the bonnet from factory, not gas struts. Aftermarket bonnet strut kits exist, but they’re not original equipment.

Popular questions about 2007 Toyota Wish gas struts

Do 2007 Toyota Wish bonnets use gas struts?
From factory, no — the bonnet uses a simple prop rod. Owners keen on hands-free lifting sometimes fit aftermarket bonnet strut kits, but they aren’t OE. If adding a kit, choose one designed for the Wish and follow the supplied mounting instructions carefully.

How long do the rear hatch gas struts typically last?
Many last 5–10 years, but it depends on climate and use. If the hatch won’t stay up, drops in cold weather, or opens sluggishly, they’re due. Replacing both sides together keeps the hatch balanced and predictable.

Can the original gas struts be re-gassed, or should they be replaced?
Most OE-style automotive gas struts are sealed and intended to be replaced rather than re-gassed. Some local specialists can re-gas certain serviceable units, but on a Wish it’s usually more practical to fit new, correct-spec struts for reliable performance.