Parts for your 2007 Toyota Kluger-Manifold gasket

2007 Toyota Kluger Manifold Gasket — What It Does and When to Replace It

Referencing technical sources, this vehicle definitely uses manifold gaskets. Toyota’s Repair Manual procedures for the Kluger/Highlander XU30 with the 3MZ‑FE V6 specify replacing the intake manifold and surge tank gaskets whenever those parts are removed, and the Toyota Electronic Parts Catalogue (EPC) lists both intake and exhaust manifold gaskets as service items for 2007 Kluger models. So yes, a manifold gasket is fitted and relevant.

On a 2007 Toyota Kluger, manifold gaskets do a quiet but critical job. The intake manifold gaskets seal the junctions between the manifold, surge tank and cylinder heads so only measured air gets in, keeping fuel trims steady and idle smooth. The exhaust manifold gaskets seal hot gases as they exit the head, preventing ticking noises, fumes under the bonnet and damage to nearby components. When these seals are healthy, the V6 runs sweet and efficient