Parts for your 2007 Toyota Hiace-Driveshafts

2007 Toyota Hiace driveshafts

Based on Toyota technical literature for the H200 Hiace (Drivetrain/Axle – Propeller Shaft section of the Toyota Repair Manual) and the Toyota Electronic Parts Catalogue (EPC listings for TRH/KDH2##: Propeller Shaft Assy PNC 37100 and Centre Support Bearing PNC 37230), the 2007 Toyota Hiace uses a driveshaft (propeller shaft) as part of its rear‑wheel‑drive layout. Long and super‑long wheelbase models commonly run a two‑piece shaft with a centre bearing. Some 4WD variants also add front CV driveshafts.

On a Hiace, the driveshaft’s job is simple but critical: it takes torque from the gearbox/transfer output and delivers it to the rear differential smoothly, across varying suspension angles. Universal joints (uni joints) and a slip section let the shaft articulate and change length as the van moves, while remaining balanced at highway speeds. On 4WD versions, front CV shafts perform a similar role to drive the front wheels.

As part of regular servicing in Australia and New Zealand, the driveshaft should get a quick once‑over at each service or at least every 10,000–15,000 kilometres. Look and listen for the tell‑tale stuff that points to wear.

• Symptoms worth noting: vibration on take‑off or at 60–90 km/h, a clunk when shifting from reverse to drive, a cyclic squeak at low speed, shudder under load, or a droning noise that rises with road speed.
• Inspection tips: check uni joints for free play or brinnelling (red/brown dust), confirm the centre bearing rubber isn’t cracked or sagging, look for missing balance weights, dents in the tube, loose flange bolts, and oil leaks at the transmission or diff flanges. For 4WD, inspect front CV boots for splits and grease fling.
• Maintenance and replacement: some Hiace uni joints are sealed/non‑greaseable