Your Selected Vehicle
Parts for your 2007 Nissan Pathfinder-Headlight bulbs
LEDAUT 24V LED Interior Light 61 PCS SMD LEDs Equivalent To 30 Watt Globe - 1061/24
LEDAUT 12V LED Interior Light 31PCS SMD LEDs Equivalent To 15 Watt Globe Blister Pack - 1031
LEDAUT 12V LED Interior Light 61PCS SMD LEDs Equivalent To 30W Globe With Switch - 1061/12SW
Explore 4WD & Adventure
OEX Sealed Beam Headlamp - High/Low 12V 100 X 165mm 60/50W 3 Blade Terminals - LLX99962
LED Autolamps 12/24V Stop/Tail/Indicator Light Clear Lens Coloured LEDs Surface Mount - 12ARM-2
LED Autolamps 12/24V LED Amber Emergency Light Flash Patterns With Sync Wire Blister Pack - 120035AM
LED Autolamps 12V Indicator Strip Lamp With 10 Square LEDs Recessed Mount - 235A12
LED Autolamps 12V Stop/Tail Strip Lamp With 10 Square LEDs Recessed Mount - 235R12
LED Autolamps Multi Volt Stop/Tail/Indicator/Reverse/Reflector LHS & RHS Diffused Tail Light - 284ARWM-2
LED Autolamps 12V LED Stop/Tail/Indicator/Licence Plate Lamp with Reflex Reflector - 99ARL
LED Autolamps Multi Volt Stop/Tail/Ind/Rev With Try Me Function Diffused Tail With Sequential Indicator Twin Blister - 385ARWM-2
LED Autolamps 12V LED Stop/Tail/Indicator Light With Reflex Reflector Twin Blister - 100BAR2
LED Autolamps 12V LED Stop/Tail/Indicator Lamps With Reflector Twin Blister - 101BAR2
LED Autolamps 12V LED Stop/Tail/Indicator Lamp With Licence Plate Lamp Blister Pack Containing Left & Right Lamps - 99ARL2
LED Autolamps 12V 2x Stop/Tail/Indicator Boat Trailer Lamps with Licence Plate Lamp, includes Left & Right Side - 207BARLP2
2007 Nissan Pathfinder headlight bulbs
Based on technical sources – the 2007 Nissan Pathfinder Owner’s Manual (Lights), the Nissan R51 Factory Service Manual (LT: Lighting System), and ADR 13/00 rules for lamp fitment – this model uses replaceable halogen headlight bulbs. So yes, headlight bulbs are relevant and fitted to the 2007 Pathfinder.
On this Pathfinder, the headlight bulbs do the heavy lifting for safe night-time and poor-weather driving, throwing a clear beam that meets ADR requirements while keeping glare down for oncoming traffic. They’re a wear item: halogen capsules slowly dim and shift colour over time, even before they blow, so brightness can taper off without being obvious.
Bulb type varies by market and trim. Many 2007 Pathfinders run a dual‑filament halogen (commonly H13/9008, some builds use HB5/9007). Always confirm against the owner’s manual, the bulb base stamp, or a VIN‑matched parts catalogue. Stick to the specified wattage (typically around 55/60–65 W) to avoid overheating the wiring and lamp housings.
- Tell-tales it’s time: noticeably dimmer output, a yellowish beam, flickering, or one side out.
- Best practice: replace in pairs so left and right match in colour and brightness.
- Service rhythm: many drivers refresh halogens every 3–5 years or ~60,000–100,000 km, depending on night driving and DRL usage.
Under the bonnet, access is from behind the headlamp. Disconnect the battery negative if space is tight, unclip the dust cover, unplug the connector, then twist the bulb anti‑clockwise. Refitting is the reverse. Don’t touch the glass, skin oils create hot spots that shorten bulb life. Use clean gloves or a tissue if needed. Check the rubber boot seals well to keep moisture out, and give the headlamp lens a quick clean inside and out if there’s safe access.
After any bulb change, check headlamp aim on a flat surface at night. If the beam looks off, adjust the headlamp aiming screws as outlined in the FSM so the cut-off sits correctly and doesn’t dazzle other road users. If a new bulb doesn’t light, inspect the relevant fuse, relay, and earth points before assuming the bulb is faulty.
- Confirm bulb type and wattage.
- Work with the ignition off, disconnect negative if needed.
- Remove dust cap, unplug, and twist out old bulb.
- Fit new bulb without touching glass.
- Refit cap and connector, test lights.
- Check aim and beam pattern.
Popular questions
What headlight bulb type fits a 2007 Nissan Pathfinder?
Most 2007 Pathfinders use a dual‑filament halogen such as H13/9008, though some markets/builds use HB5/9007. Because there were regional differences, it’s smart to confirm via the owner’s manual, the stamp on the old bulb, or a VIN‑matched parts lookup so the base and wattage are spot on.
Should both headlight bulbs be replaced at the same time?
Yes. Halogen bulbs dim with age, so replacing both keeps the colour and brightness matched. It also saves time, avoids uneven illumination, and helps maintain a correct, balanced beam pattern when the lamps are re‑aimed after fitting.
Why avoid touching the glass on a new bulb?
Skin oils leave residue that causes a hot spot on the quartz when the bulb heats up, which can lead to early failure or a cloudy bulb. Handle the metal base only, or use clean gloves or tissue. If you do touch the glass, wipe it with isopropyl alcohol and let it dry before installation.