Your Selected Vehicle
Parts for your 2007 Nissan Pathfinder-Headlight bulbs
LED Autolamps 12V Round Indicator Lamp With Amber Lens Recessed Mount 130mm Diameter - 102A
LED Autolamps Twin function rear position with supplementary rear indicator - 97CRIMB
Explore 4WD & Adventure
LED Autolamps Multi Volt Indicator Lamp With Clear Lens And Chrome Reflector Blister Pack - 131CAM
LED Autolamps Twin function side indicator with amber side marker - 97AIMCSB
LED Autolamps Twin function side indicator with amber/red side marker - 97ARIMCSB
LED Autolamps Twin function rear position with supplementary rear indicator - 97RIM
LED Autolamps Twin function side indicator with amber/red side marker - 97ARIM
LED Autolamps 12/24V Rear Indicator Light With Amber Lens Blister Pack - 113AMG
LED Autolamps 10/30V Chrome Series LED Red Amber Side Marker With 40cm Wire - 35CCARM
LED Autolamps Twin function front position with supplementary front indicator - 97WIMB
LED Autolamps Twin function front position with supplementary front indicator - 97CWIM
LED Autolamps Twin function front position with supplementary front indicator - 97CWIMCSB
LED Autolamps Multi Volt Stop/Tail/Indicator Lamp 190x95x28mm Blister Pack - 280ARM
LED Autolamps 12/24 Multi Volt Stop/Tail Lamp 36 LEDs With 40cm Wire - 80RM
LED Autolamps 12V Round Stop/Tail Lamp With Red Lens Recessed Mount - 102R
2007 Nissan Pathfinder headlight bulbs
Based on technical sources – the 2007 Nissan Pathfinder Owner’s Manual (Lights), the Nissan R51 Factory Service Manual (LT: Lighting System), and ADR 13/00 rules for lamp fitment – this model uses replaceable halogen headlight bulbs. So yes, headlight bulbs are relevant and fitted to the 2007 Pathfinder.
On this Pathfinder, the headlight bulbs do the heavy lifting for safe night-time and poor-weather driving, throwing a clear beam that meets ADR requirements while keeping glare down for oncoming traffic. They’re a wear item: halogen capsules slowly dim and shift colour over time, even before they blow, so brightness can taper off without being obvious.
Bulb type varies by market and trim. Many 2007 Pathfinders run a dual‑filament halogen (commonly H13/9008, some builds use HB5/9007). Always confirm against the owner’s manual, the bulb base stamp, or a VIN‑matched parts catalogue. Stick to the specified wattage (typically around 55/60–65 W) to avoid overheating the wiring and lamp housings.
- Tell-tales it’s time: noticeably dimmer output, a yellowish beam, flickering, or one side out.
- Best practice: replace in pairs so left and right match in colour and brightness.
- Service rhythm: many drivers refresh halogens every 3–5 years or ~60,000–100,000 km, depending on night driving and DRL usage.
Under the bonnet, access is from behind the headlamp. Disconnect the battery negative if space is tight, unclip the dust cover, unplug the connector, then twist the bulb anti‑clockwise. Refitting is the reverse. Don’t touch the glass, skin oils create hot spots that shorten bulb life. Use clean gloves or a tissue if needed. Check the rubber boot seals well to keep moisture out, and give the headlamp lens a quick clean inside and out if there’s safe access.
After any bulb change, check headlamp aim on a flat surface at night. If the beam looks off, adjust the headlamp aiming screws as outlined in the FSM so the cut-off sits correctly and doesn’t dazzle other road users. If a new bulb doesn’t light, inspect the relevant fuse, relay, and earth points before assuming the bulb is faulty.
- Confirm bulb type and wattage.
- Work with the ignition off, disconnect negative if needed.
- Remove dust cap, unplug, and twist out old bulb.
- Fit new bulb without touching glass.
- Refit cap and connector, test lights.
- Check aim and beam pattern.
Popular questions
What headlight bulb type fits a 2007 Nissan Pathfinder?
Most 2007 Pathfinders use a dual‑filament halogen such as H13/9008, though some markets/builds use HB5/9007. Because there were regional differences, it’s smart to confirm via the owner’s manual, the stamp on the old bulb, or a VIN‑matched parts lookup so the base and wattage are spot on.
Should both headlight bulbs be replaced at the same time?
Yes. Halogen bulbs dim with age, so replacing both keeps the colour and brightness matched. It also saves time, avoids uneven illumination, and helps maintain a correct, balanced beam pattern when the lamps are re‑aimed after fitting.
Why avoid touching the glass on a new bulb?
Skin oils leave residue that causes a hot spot on the quartz when the bulb heats up, which can lead to early failure or a cloudy bulb. Handle the metal base only, or use clean gloves or tissue. If you do touch the glass, wipe it with isopropyl alcohol and let it dry before installation.