Parts for your 2007 Honda Odyssey-Driveshafts

2007 Honda Odyssey driveshafts

Referencing Honda’s factory service information for the 2005–2010 Odyssey (Front Axle/Driveshafts sections) and OEM parts catalogues, the 2007 Honda Odyssey is a front‑wheel‑drive vehicle that uses two front driveshaft (CV axle) assemblies. There is no rear propeller shaft fitted, as no AWD system was offered for this model year.

On the 2007 Odyssey, the driveshafts (often called CV axles or half‑shafts) send engine torque from the transaxle to the front wheels while allowing for suspension travel and steering angle. Each shaft has inner and outer constant‑velocity (CV) joints packed with grease and sealed by flexible rubber boots. The right‑hand side uses an intermediate shaft with a support bearing to balance shaft lengths and reduce torque steer, a common Honda setup of the era.

As part of regular servicing, it’s smart to inspect the CV boots every service interval. A quick look behind the front wheels for split boots or thrown grease on the inner guards, struts, or lower arms can save a bigger bill later. If caught early, a torn boot can sometimes be rebooted