Your Selected Vehicle
Parts for your 2006 Nissan Maxima-Headlights
LED Autolamps LED Autolamps Indicator LED Light Round Amber Lens w/Rubber Grommet and Plug 12/24v - 110AMG
LED Autolamps 12V LED Stop/Tail/Indicator Lamp With Reflex Reflector 2 Pack - 151BAR2
Explore 4WD & Adventure
LED Autolamps Twin Function Stalk Side Indicator With Red/Amber Side Marker RHS Multivolt - 805ARIMR
LED Autolamps Multi Volt Stop/Tail/Indicator Lamp With Reflex Reflectors Grey Base Blister Pack 1 pce - 100ARM
LED Autolamps Multi Fit Steel Bracket To Suit 280/282/275/80/283/284 Triple Combination Lamps - MFBKT
LED Autolamps Twin function rear position with supplementary rear indicator - 97RIM
LED Autolamps Multi Volt Stop/Tail/Indicator/Reverse Assembly With 4 Lamps - 80BARRWM
LED Autolamps RHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284RHS
LED Autolamps Multi Volt Rear Combination LED Lamp With Grey Housing And Base - 275GARWMB
LED Autolamps 12V Front Indicator Amber Lens Black Base Twin Blister Pack - 175A/2
LED Autolamps Tray Conversion Kit To suits Hilux Contains Two Cables - PATCH-HILUX
LED Autolamps 174 Series Stop/Tail/Indicator Lamp 12/24V, Surface Mount, 40cm Cable - 174ARMB
LED Autolamps 12/24V 16 LED Stop/Tail Indicator Lamp Black Bracket Blister Pack - 201BSTIM
LED Autolamps 12V Interior Strip lamp Touch Sensor Switch With MCU Circuitry - 40260SMCU
2006 Nissan Maxima Headlights — Purpose, Care, and When to Replace
Based on the 2006 Nissan Maxima owner’s manual, Nissan parts catalogues, and the factory service manual, this model is fitted with front headlights as standard equipment. Depending on trim and market, the Maxima may have halogen or HID/Xenon low beams with separate high beams, so the part is absolutely relevant to servicing and safety.
The headlights on a 2006 Nissan Maxima do the heavy lifting after dark: they illuminate the road ahead, make the car visible to others, and help define lane edges and hazards in wet or foggy conditions. Good light output and correct beam aim are crucial for meeting local road rules in Australia and New Zealand and for keeping night drives stress-free.
For routine servicing, it’s wise to check headlight operation at each oil change. Look for uneven brightness, flicker, haze on the lenses, or moisture inside the housing. Replace bulbs in pairs to keep beam colour and intensity consistent. On halogen systems, avoid touching the glass with bare fingers, skin oils can shorten bulb life. For HID/Xenon variants, be mindful there’s high voltage in the ballast—switch the lights off and let them sit for a few minutes before unplugging connectors.
When replacing, confirm the correct bulb types for the specific trim (some use halogen for both beams, others use HID low beam with a halogen high). Use quality bulbs that match the original wattage and colour temperature to avoid wiring stress and glare. If light output has faded over time, consider a proper plastic lens restoration kit rather than aggressive polishing that can remove UV protection.
Beam aim matters. If the front end has been repaired, springs have sagged, or the car often tows, re-aim the lights using the adjusters on the headlamp assembly and a flat wall test. Check fuses and the headlight relay if one side is dead, intermittent faults often trace back to corroded connectors—use dielectric grease sparingly on clean terminals. A small amount of condensation after rain can be normal, persistent fogging suggests a compromised seal that should be addressed to protect bulbs and electronics.
- Inspect operation and lens clarity at each service.
- Replace bulbs in pairs, match OEM spec.
- Re-aim after suspension or body work.
- Treat HID components with extra caution.
FAQs
What bulb type does a 2006 Nissan Maxima use?
Depending on trim and market, it may use halogen bulbs for both beams or an HID/Xenon low beam with a halogen high beam. Always check the owner’s manual or the markings on the headlamp housing to confirm the exact types before buying replacements.
Why are my Maxima’s headlights dim or flickering?
Common causes include ageing bulbs, oxidised lenses, poor earths, tired ballasts (on HID systems), or voltage drop from corroded connectors. Start with lens restoration and fresh bulbs, if flicker persists on HID, inspect the ballast and wiring.
How do I adjust headlight aim on a 2006 Maxima?
Park on level ground facing a wall, 3–5 metres back. Mark headlight centrelines on the wall, then use the vertical and, if fitted, horizontal adjusters on each headlamp to set the cut-off just below the marks. Avoid over-aiming high, which can create glare for oncoming traffic.