Your Selected Vehicle
Parts for your 2005 Toyota Vitz|yaris-Headlight bulbs
LEDAUT 24V LED Interior Light 61 PCS SMD LEDs Equivalent To 30 Watt Globe - 1061/24
LEDAUT 12V LED Interior Light 31PCS SMD LEDs Equivalent To 15 Watt Globe Blister Pack - 1031
LEDAUT 12V LED Interior Light 61PCS SMD LEDs Equivalent To 30W Globe With Switch - 1061/12SW
Explore 4WD & Adventure
LED Autolamps 12/24V Stop/Tail/Indicator Light Clear Lens Coloured LEDs Surface Mount - 12ARM-2
LED Autolamps 12/24V LED Amber Emergency Light Flash Patterns With Sync Wire Blister Pack - 120035AM
LED Autolamps 12V Indicator Strip Lamp With 10 Square LEDs Recessed Mount - 235A12
LED Autolamps 12V Stop/Tail Strip Lamp With 10 Square LEDs Recessed Mount - 235R12
LED Autolamps Multi Volt Stop/Tail/Indicator/Reverse/Reflector LHS & RHS Diffused Tail Light - 284ARWM-2
LED Autolamps 12V LED Stop/Tail/Indicator/Licence Plate Lamp with Reflex Reflector - 99ARL
LED Autolamps Multi Volt Stop/Tail/Ind/Rev With Try Me Function Diffused Tail With Sequential Indicator Twin Blister - 385ARWM-2
LED Autolamps 12V LED Stop/Tail/Indicator Light With Reflex Reflector Twin Blister - 100BAR2
LED Autolamps 12V LED Stop/Tail/Indicator Lamps With Reflector Twin Blister - 101BAR2
LED Autolamps 12V 2x Stop/Tail/Indicator Boat Trailer Lamps with Licence Plate Lamp, includes Left & Right Side - 207BARLP2
LED Autolamps 12/24V Amber Emergency Mini Light Bar Clear Lens With Amber LEDs 18 Selectable Flash Patterns - LB380ACM
LED Autolamps 10/30V Front Outline Position Marker With 2 White LED Blister Pack - 58WM
LED Autolamps 12/24V LED MaxiLamp Stop/Tail/Indicator/Reflector Light Round Blister Pack - MAXILAMP1XC
LED Autolamps 90 Series Green Emergency LED Strobe/Warning Light 12V/24V Surface Mount - 90GM
LED Autolamps 10/30V Amber Emergency Light Bar Clear Lens With Amber LEDs 10 Selectable Flash Patterns - LB1345ACM
LED Autolamps 10/30V Amber Emergency Bar Clear Lens With Amber LEDs 19 Selectable Flash Patterns - LB964ACM
2005 Toyota Vitz/Yaris Headlight Bulbs
Based on technical sources including the Toyota Repair Manual for the XP90 platform, the 2005 Toyota Vitz/Yaris Owner’s Manual, and industry bulb catalogues from OE suppliers (e.g., Koito, Philips), this model uses replaceable halogen headlight bulbs. Depending on market and headlamp design, it’s typically either an H4 dual‑filament bulb (low/high in one) or separate bulbs such as 9006/HB4 for low beam and 9005/HB3 for high beam. The headlight bulbs are therefore absolutely relevant and serviceable items on a 2005 Toyota Vitz/Yaris.
The headlight bulbs do the grunt work of throwing a safe, legal beam pattern so the driver can see the road and be seen by others. In a 2005 Toyota Vitz/Yaris, the reflectors and lens are designed around halogen bulbs, so correct wattage and base type matter for visibility, ADR/WOF compliance, and not cooking the housing.
As halogens age, they go dull and yellow before they finally blow. Owners will often notice the light output drop off at night, especially in wet weather. It’s smart practice to replace in pairs every 3–5 years or roughly 60,000–100,000 km, even if one’s still working. Keep the lenses clean, check for moisture inside the housing, and don’t touch the glass when fitting new bulbs—skin oils can shorten bulb life. After any bulb change, verify the beam aim to avoid dazzling oncoming traffic and to pass WOF/regos without drama.
Replacement is straightforward on most 2005 Toyota Vitz/Yaris variants: pop the bonnet, unplug the connector, release the rubber boot and spring clip (H4) or twist-lock (HB3/HB4), swap the bulb like-for-like, and refit in reverse. Stick with the specified wattage (commonly 60/55 W for H4, or 55 W for HB3/HB4). If the headlights still seem dim after fresh bulbs, the issue might be cloudy lenses or a poor earth connection rather than the bulbs themselves.
- Signs it’s time to replace: dim or yellow output, one side out, flickering, or mismatched colour.
- Tip: Keep a spare matched pair in the glovebox for road trips.
What headlight bulb fits a 2005 Toyota Vitz/Yaris?
Most use an H4 dual‑filament bulb, while some markets/models use HB4 (9006) low beam and HB3 (9005) high beam. The exact type is printed on the back of the headlamp housing and listed in the owner’s manual. It’s best to match the build date and lamp markings before buying.
How often should the headlight bulbs be changed?
Replace when dim or failed, and consider preventative replacement every 3–5 years or 60,000–100,000 km. Halogens slowly lose brightness over time, so changing both sides together keeps the beam colour and intensity even.
Can they upgrade to LED bulbs?
Retrofit LED bulbs in halogen housings can affect beam pattern and may not meet ADR/NZS compliance, risking WOF failure or glare to others. If considering LEDs, choose compliant kits proven in this headlamp type, or stick with quality halogen upgrades designed for road use.