Parts for your 2005 Toyota Kluger-Centre bearing

2005 Toyota Kluger centre-bearing — what’s fitted and what matters

Technical sources including the Toyota Repair Manual for the XU20-series Kluger/Highlander (Propeller Shaft section) and the Toyota Electronic Parts Catalogue (Australasia, MCU28R AWD) show that 2005 Kluger all-wheel drive (AWD) variants run a two-piece tailshaft (propeller shaft) with a centre support bearing. Front-wheel drive (2WD/FWD) Kluger models don’t have a tailshaft to the rear diff, so a centre-bearing isn’t used or relevant on those vehicles.

For AWD 2005 Kluger models, the centre-bearing sits mid-way along the two-piece tailshaft, cradled in a rubber mount and bolted to the body. Its job is to support and steady the rotating shaft, keeping driveline angles true and quelling vibration as torque is sent to the rear differential. When the bearing or its rubber isolator wears, owners often notice a shudder on take-off, a droning or humming at certain speeds, or a thump on overrun.

As part of regular servicing on an AWD Kluger, a quick check of the centre-bearing pays off. With the vehicle safely raised, a technician will inspect the rubber hanger for cracking or separation, spin the shaft to feel for roughness, and check for play by hand. Any binding, rumble, or visible damage is a sign the assembly is due for replacement.

Replacement on these models is straightforward but benefits from careful setup. The tailshaft should be paint-marked before disassembly to preserve phasing, flanges cleaned, and fasteners torqued to spec on reassembly. If the bearing is supplied as part of a support assembly, it’s wise to fit the complete unit rather than pressing just the bearing, which can stress the rubber isolator. After refit, a road test for vibration under load and at cruise confirms the result.

• Tell-tale symptoms: take-off shudder, mid-car drone, vibration under load.
• Service tip: inspect the hanger rubber and bearing play at each major service interval, especially on higher-kilometre vehicles.
• Good practice: keep the shaft phased as marked and recheck fasteners after a short settling period.

For 2WD/FWD 2005 Kluger variants, no centre-bearing is fitted because there’s no rear driveshaft