Parts for your 2005 Nissan Serena-Centre bearing

2005 Nissan Serena centre-bearing — what’s fitted and what’s not

For a 2005 Nissan Serena, a centre-bearing (centre support bearing) is only relevant on 4WD/AWD variants that use a two-piece propeller shaft to drive the rear wheels. On the common 2WD/FF models, there’s no prop shaft at all, just front drive shafts, so a centre-bearing isn’t used. This isn’t guesswork—Nissan’s workshop documentation details it: the Serena service manuals include a Propeller Shaft section for 4WD models (showing a two-piece shaft and centre bearing), while 2WD models are covered under transaxle and front drive shaft sections only, with no centre support bearing shown. Referenced sources include the Nissan Serena C24/C25 Workshop Manuals (Propeller Shaft and Driveline sections) and the Nissan FAST electronic parts catalogue for 2005 build vehicles.

Why 2WD models don’t use one: the front-wheel-drive layout packages the engine, transaxle and drive shafts up front, eliminating the need for a long propeller shaft to the rear. No long shaft means no need for a centre support. That’s why a centre-bearing isn’t fitted or required on 2WD Serenas.

For 4WD 2005 Serena variants that do have a centre-bearing, the part’s job is straightforward: it supports the mid-point of the two-piece prop shaft, keeping the rotating mass stable, aligned and quiet across all speeds. By cradling the shaft in a rubber-insulated bearing, it controls vibration, reduces drumming in the cabin, and helps protect the universal joints and diff pinion from shock loads.

Owners should treat the centre-bearing as a wear item. Typical signs it’s on the way out include a low-speed shudder on take-off, a droning or humming that’s speed-related (often 60–90 km/h), and a thump or clunk as drive is taken up. A quick visual can reveal cracked rubber, sagging of the hanger, or shiny rub marks from misalignment.

• Inspection tips: check the rubber cushion for splits, ensure the bracket is tight, and look for rust trails around the bearing seal.
• Service interval: give it a look at regular services (10,000–15,000 km) or sooner if vibration appears.
• Related checks: verify prop shaft phasing marks, U-joint play, diff mount and rear engine mount condition.

Replacement on a Serena 4WD generally means removing the prop shaft assembly, marking flange positions for phasing, pressing off the old bearing, and pressing on the new one with the correct orientation. It’s wise to replace the hanger bracket nuts/bolts and any centre-bearing dust seals. Keep the shaft supported so the slip joint isn’t over-extended, and re-torque the flanges evenly. After refit, a short road test at suburban and highway speeds will confirm the vibration is gone. If any buzz remains, have the shaft balance checked and re-confirm mount condition. Quality aftermarket or genuine bearings are both viable