Your Selected Vehicle
Parts for your 2005 Honda Odyssey-Headlights
LED Autolamps 12/24 Multi Volt Stop/Tail Lamp 36 LEDs With 40cm Wire - 80RM
LED Autolamps Twin function side indicator with amber side marker - 97AIMCSB
LED Autolamps Twin function rear position with supplementary rear indicator - 97RIM
Explore 4WD & Adventure
LED Autolamps 12V Round Stop/Tail Lamp With Red Lens Recessed Mount - 102R
LED Autolamps Twin function side indicator with amber/red side marker - 97ARIMCSB
LED Autolamps Twin function front position with supplementary front indicator - 97CWIM
LED Autolamps 12/2V Maxilamp LED Stop/Tail/Indicator/Reflector Black Chrome Bolt Mount - MAXILAMPC1XCE
LED Autolamps 12/24V Rear Indicator Lamp Red Reflector Blister Pack - 460AM
LED Autolamps Amber LED Indicator Lamp Insert For J3 Series Blister Pack - J3AM
LED Autolamps Multi Volt Stop/Tail/Indicator Lamp 190x95x28mm Blister Pack - 280ARM
LED Autolamps Red LED Stop/Tail Lamp Insert For J3 Series Blister Pack - J3RM
LED Autolamps Multi Volt Rear Combination LED Lamp With Grey Housing And Base - 275GARWMB
LED Autolamps Rear End Outline LED Marker Red 12/24v Red Lens 16cm Cable Blister Pack - 42RM
LED Autolamps Twin function front position with supplementary front indicator - 97CWIMB
LED Autolamps 12V Stop/Tail/Indicator Lamp With Reflex Reflector 100x100x25mm - 100BAR
LED Autolamps Twin function side indicator with amber/red side marker - 97ARIMB
2005 Honda Odyssey headlights: purpose, care, and easy replacement tips
Headlights are absolutely fitted and relevant on the 2005 Honda Odyssey. The Honda Owner’s Manual and factory service information for the 2005 model year, along with lighting requirements such as ADR 13/00 and NZTA Warrant of Fitness rules, specify dipped (low) and main (high) beams as standard safety equipment.
On this Odyssey, the headlights let the driver see clearly at night and in poor weather, and make the vehicle visible to others. Low beam handles everyday road use without dazzling oncoming traffic, while high beam extends reach on open roads. Clear, correctly aimed headlamps are a must for passing rego/WoF checks and for everyday safety.
When to think about replacement? If the globes are dimming, flickering, or one’s out, it’s time. Yellowed or cloudy lenses, moisture inside the housing, or cracked mounts also knock back performance. Halogen globes do fade with age, so swapping them in pairs keeps the light colour and brightness consistent left to right.
- Use the correct globe type and wattage to stay ADR/NZTA compliant.
- Avoid touching the glass, handle new globes by the base or use gloves.
- Check fuses, connectors, and earths if a new globe doesn’t light.
- After any front-end work, recheck headlight aim to avoid glare.
Most 2005 Odyssey variants run halogen globes: typically HB4 (9006) for low beam and HB3 (9005) for high beam. Some higher-spec or JDM imports may use HID/Xenon low beams (often D2S) with a ballast. Because trims and markets vary, it’s smart to confirm by checking the owner’s manual, the markings on the old globe, or your VIN in the parts catalogue.
Access is usually from behind the headlamp under the bonnet, space can be a bit tight near the battery or airbox. Refit dust caps properly to keep moisture out, and consider a dab of dielectric grease on connectors to prevent corrosion. If lenses are cloudy, a proper headlight restoration kit can bring back clarity, if there’s persistent condensation, inspect seals and dust caps. Finally, stick with quality, road-legal globes rather than questionable LED/HID retrofit kits in halogen housings, which can cause glare and may fail WoF/regulatory checks.
Popular questions about 2005 Honda Odyssey headlights
What headlight globes fit a 2005 Honda Odyssey?
Most run halogen HB4 (9006) low beam and HB3 (9005) high beam. Some higher-spec/JDM imports may use HID/Xenon low beams such as D2S with ballasts. Because markets and trims differ, confirm via the owner’s manual, the old globe’s markings, or your VIN.
Should globes be replaced in pairs?
Yes. Halogen globes dim over time, so replacing both keeps brightness and colour even. It also saves a second trip under the bonnet when the other side inevitably goes a few weeks later.
Are LED or HID retrofit kits legal in AU/NZ?
Generally not if installed in halogen reflector housings. ADR/NZTA rules expect the correct housing type and, for HID, often self-levelling and washers. Poorly matched retrofits can cause glare and may fail rego/WoF. Use road-legal globes or purpose-built projector assemblies designed for LED/HID.