Your Selected Vehicle
Parts for your 2005 Holden Barina-Pedal pads
Explore 4WD & Adventure
2005 Holden Barina pedal pads — what they do and when to replace them
Pedal pads are absolutely used on the 2005 Holden Barina (TK). Technical references such as the factory workshop manual and the Holden/GM electronic parts catalogue for the TK Barina list serviceable rubber covers for the brake pedal (and the clutch pedal on manuals). The accelerator is typically a moulded pedal assembly without a removable rubber pad. So, yes—pedal pads are relevant on this model.
On a Barina, pedal pads exist to give sure-footed grip in wet or dusty conditions, protect the metal pedal plate from wear, and offer a bit of cushioning so long drives don’t feel harsh underfoot. They’re a small, inexpensive part, but they pull a lot of safety weight—if the pad goes hard, cracks, or turns smooth and shiny, shoes can slip, especially with wet soles or work boots.
For servicing, it’s smart to check the pedal pads at each routine service. Replacement is quick and budget-friendly, making it a no-brainer whenever there’s visible wear. If the vehicle’s a manual, inspect both brake and clutch pads, on autos, it’s just the brake. The accelerator pedal face is usually a fixed plastic tread and isn’t treated as a separate pad.
- Signs it’s time to replace: surface gone smooth or glossy, visible cracks, edges curling, pad shifting on the pedal, or reduced grip with wet shoes.
- Driving feel: slipping underfoot, needing extra pressure to feel secure, or inconsistent pedal feedback.
Replacement tips for a Barina are straightforward:
- Pop off the old rubber cover (work from a corner). If it’s brittle, it may break—no drama.
- Clean the bare metal pedal plate so there’s no grit or old rubber left.
- Warm the new pad slightly (sunlight or warm water) to make it more pliable.
- Hook the bottom lip first, then stretch the pad over the pedal until all edges seat in their grooves.
- Press all around to confirm it’s fully home, then test foot feel before driving.
Stick with genuine or ADR-compliant aftermarket pads for proper fit and grip. Be wary of thick, clamp-on alloy covers that can reduce clearance or slip when wet. And always keep floor mats clipped in so they can’t foul the pedals. Look after the pedal pads and the Barina’s controls will feel safe, consistent and tidy for years.
FAQs
Do all 2005 Barinas have pedal pads?
Yes. The brake pedal has a removable rubber pad on both auto and manual models, and manuals add a clutch pedal pad. The accelerator is usually a one-piece plastic pedal without a separate pad.
How often should pedal pads be replaced?
There’s no set kilometre interval—replace whenever they’re worn smooth, cracked, hard, or starting to slip. For many Barinas that’s every few years, but heavy city driving or wet work boots can wear them sooner.
Can universal pedal covers be used?
Only if they’re a snug, secure fit and meet local standards. Avoid thick or screw-on covers that can reduce clearance or slip. If in doubt, go genuine or a known ADR-compliant aftermarket option made for the TK Barina.
