Your Selected Vehicle
Parts for your 2004 Suzuki Jimny-Headlight bulbs
LEDAUT 24V LED Interior Light 61 PCS SMD LEDs Equivalent To 30 Watt Globe - 1061/24
LEDAUT 12V LED Interior Light 31PCS SMD LEDs Equivalent To 15 Watt Globe Blister Pack - 1031
LEDAUT 12V LED Interior Light 61PCS SMD LEDs Equivalent To 30W Globe With Switch - 1061/12SW
Explore 4WD & Adventure
OEX Sealed Beam Headlamp - High/Low 12V 100 X 165mm 60/50W 3 Blade Terminals - LLX99962
LED Autolamps 12/24V Stop/Tail/Indicator Light Clear Lens Coloured LEDs Surface Mount - 12ARM-2
LED Autolamps 12/24V LED Amber Emergency Light Flash Patterns With Sync Wire Blister Pack - 120035AM
LED Autolamps 12V Indicator Strip Lamp With 10 Square LEDs Recessed Mount - 235A12
LED Autolamps 12V Stop/Tail Strip Lamp With 10 Square LEDs Recessed Mount - 235R12
LED Autolamps Multi Volt Stop/Tail/Indicator/Reverse/Reflector LHS & RHS Diffused Tail Light - 284ARWM-2
LED Autolamps 12V LED Stop/Tail/Indicator/Licence Plate Lamp with Reflex Reflector - 99ARL
LED Autolamps Multi Volt Stop/Tail/Ind/Rev With Try Me Function Diffused Tail With Sequential Indicator Twin Blister - 385ARWM-2
LED Autolamps 12V LED Stop/Tail/Indicator Light With Reflex Reflector Twin Blister - 100BAR2
LED Autolamps 12V LED Stop/Tail/Indicator Lamps With Reflector Twin Blister - 101BAR2
LED Autolamps 12V 2x Stop/Tail/Indicator Boat Trailer Lamps with Licence Plate Lamp, includes Left & Right Side - 207BARLP2
2004 Suzuki Jimny Headlight Bulbs
Headlight bulbs are absolutely relevant and used on the 2004 Suzuki Jimny. The model runs replaceable halogen globes: H4 dual‑filament, 12V 60/55W. This fitment is specified in the Suzuki Jimny (SN413) owner’s manual bulb chart and is echoed by major bulb catalogues and application guides used in workshops across AU/NZ, including Narva and OSRAM/Philips listings for 1998–2005 Jimny models.
On a 2004 Jimny, the H4 globe handles both low and high beam in the one bulb. Its job is simple but vital: throw a clean, well‑aimed beam so night driving, rural trips, and wet‑weather commutes stay safe. Over time, halogen filaments age, output drops, and colour shifts, so even before a globe fully blows, visibility can suffer.
As part of routine servicing, it’s smart to check headlight brightness and beam pattern. If one globe fails, replace both so the colour and output match. Stick with the OEM spec 60/55W to avoid heat damage or wiring stress. If chasing more punch, choose quality +performance H4 halogens compliant with ADR/NZS rules rather than over‑wattage options.
- Open the bonnet and unplug the headlight connector from the rear of the housing.
- Peel back the rubber dust boot and unclip the spring retainer.
- Remove the old H4 globe. Avoid touching the glass on the new one, use gloves or the box.
- Seat the new globe with the locating tabs aligned, refit the spring, boot, and connector.
- Test low and high beam, then check headlight aim against a flat wall.
If the beam looks scattered or dim after fitting, inspect the lens for haze and the housing for moisture. A light polish of the exterior plastic lens can restore a lot of lost output. For LED conversions, be mindful: many drop‑ins won’t produce a legal or safe beam in the Jimny’s reflector and may not pass WOF/roadworthy—choose ADR/NZS‑compliant kits only, if permitted.
Service tip: keep a spare H4 in the glovebox and do a quick night‑time check once a month. It’s cheap insurance for winter mornings and late‑arvo trail runs.
Popular questions about 2004 Suzuki Jimny headlight bulbs
What bulb type does a 2004 Jimny use?
It takes an H4 halogen dual‑filament globe, 12V 60/55W, covering both low and high beam. That spec is the go‑to across AU/NZ parts counters and aligns with Suzuki’s bulb chart for the SN413 Jimny.
How often should the bulbs be replaced?
There’s no hard interval, but many halogens lose brightness after 2–3 years. Replace at the first sign of dimming, colour change, or if one fails—swap both sides together for even light and colour.
Can LED bulbs be fitted to a 2004 Jimny?
They can be physically fitted, but many generic LEDs don’t form a proper beam in the Jimny’s reflector and may not be legal. If considering LEDs, choose ADR/NZS‑compliant options and check local rules and inspection requirements.