Your Selected Vehicle
Parts for your 2004 Suzuki Jimny-Headlight bulbs
LED Autolamps Multi Volt Stop/Tail/Indicator Lamp Black Bracket With 40cm Wire - 80BSTIM
LED Autolamps 24V Front Indicator And Park Light Chrome Bezel Blister Pack - 285CAW24
LED Autolamps Twin Function Stalk Side Indicator With Red/Amber Side Marker LHS Multivolt - 805ARIML
LEDAUT - Driving Light/Light Bar Patch Suits Triton MQ - DLPATCH-TRITONMQ
Explore 4WD & Adventure
LED Autolamps 12V Blue Courtesy Lamp Super Small Design Twin Blister Pack - 16B12-2
LED Autolamps 275GARWM + 2 X LR12 + 450mm Loom DT04 Connector And 500mm LP Cable - SO275GARWM2LR450
LED Autolamps 12V Stop/Tail/Indicator/Reverse With Reflectors And 500mm LP Cable - SO283ARWM2LR12
LED Autolamps 12/24 Multi Volt Stop/Tail/Indicator/Reverse Assembly Lamp With 108 LEDs - 80BARWM
LED Autolamps 12/2V Maxilamp LED Stop/Tail/Indicator/Reflector Black Chrome Bolt Mount - MAXILAMPC1XCE
LED Autolamps 12V 82 Series Stop/Tail/Indicator/Reverse Lamp Black Bracket - 82BARW
LED Autolamps 12/24V Reverse Lamp Horizontal/Vertical Mount Twin Blister - 11WM-2
LED Autolamps 174 Series Rear Indicator Lamp 12/24V, Surface Mount, 40cm Cable - 174AMB
LED Autolamps Multi Volt Round Indicator Lamp With Amber Lens Recessed Mount - 102AM
2004 Suzuki Jimny Headlight Bulbs
Headlight bulbs are absolutely relevant and used on the 2004 Suzuki Jimny. The model runs replaceable halogen globes: H4 dual‑filament, 12V 60/55W. This fitment is specified in the Suzuki Jimny (SN413) owner’s manual bulb chart and is echoed by major bulb catalogues and application guides used in workshops across AU/NZ, including Narva and OSRAM/Philips listings for 1998–2005 Jimny models.
On a 2004 Jimny, the H4 globe handles both low and high beam in the one bulb. Its job is simple but vital: throw a clean, well‑aimed beam so night driving, rural trips, and wet‑weather commutes stay safe. Over time, halogen filaments age, output drops, and colour shifts, so even before a globe fully blows, visibility can suffer.
As part of routine servicing, it’s smart to check headlight brightness and beam pattern. If one globe fails, replace both so the colour and output match. Stick with the OEM spec 60/55W to avoid heat damage or wiring stress. If chasing more punch, choose quality +performance H4 halogens compliant with ADR/NZS rules rather than over‑wattage options.
- Open the bonnet and unplug the headlight connector from the rear of the housing.
- Peel back the rubber dust boot and unclip the spring retainer.
- Remove the old H4 globe. Avoid touching the glass on the new one, use gloves or the box.
- Seat the new globe with the locating tabs aligned, refit the spring, boot, and connector.
- Test low and high beam, then check headlight aim against a flat wall.
If the beam looks scattered or dim after fitting, inspect the lens for haze and the housing for moisture. A light polish of the exterior plastic lens can restore a lot of lost output. For LED conversions, be mindful: many drop‑ins won’t produce a legal or safe beam in the Jimny’s reflector and may not pass WOF/roadworthy—choose ADR/NZS‑compliant kits only, if permitted.
Service tip: keep a spare H4 in the glovebox and do a quick night‑time check once a month. It’s cheap insurance for winter mornings and late‑arvo trail runs.
Popular questions about 2004 Suzuki Jimny headlight bulbs
What bulb type does a 2004 Jimny use?
It takes an H4 halogen dual‑filament globe, 12V 60/55W, covering both low and high beam. That spec is the go‑to across AU/NZ parts counters and aligns with Suzuki’s bulb chart for the SN413 Jimny.
How often should the bulbs be replaced?
There’s no hard interval, but many halogens lose brightness after 2–3 years. Replace at the first sign of dimming, colour change, or if one fails—swap both sides together for even light and colour.
Can LED bulbs be fitted to a 2004 Jimny?
They can be physically fitted, but many generic LEDs don’t form a proper beam in the Jimny’s reflector and may not be legal. If considering LEDs, choose ADR/NZS‑compliant options and check local rules and inspection requirements.