Parts for your 2004 Nissan Primera-Suspension bushes

2004 Nissan Primera suspension bushes

Suspension bushes are absolutely used on the 2004 Nissan Primera (P12). This is confirmed by the Nissan Primera P12 Service Manual (2002–2006), notably sections FAX (Front Axle) and RSU (Rear Suspension), which detail the front lower control arm bushes, stabiliser (anti-roll) bar D-bushes and link bushes, plus multiple rear suspension arm and subframe bushes. The Nissan FAST electronic parts catalogue also lists these bushings by part number, and leading aftermarket catalogues such as SuperPro, Nolathane and Whiteline publish direct-fit bush kits for the P12 platform. So yes—bushes are on the car and they do a lot of work.

On a 2004 Primera, the bushes isolate vibration while allowing the suspension arms and subframes to move in a controlled way. Up front, the MacPherson strut layout uses lower control arm bushes (front and large rear compliance bush) and stabiliser bar bushes to keep steering feel tight and tyre contact consistent. Down the back, the multi-link setup relies on multiple arm and subframe bushes to maintain rear toe and camber, which is key for stable cornering and tidy tyre wear.

Because they’re rubber (or polyurethane when upgraded), bushes age with heat, road grime and the odd oil leak. Typical signs they’re tired include:

• Clunks or knocks over bumps, especially from the front corners
• Wandering steering, tramlining, or a tug under brakes
• Uneven or rapid tyre wear
• Shudder on take-off or vibration through the cabin

For regular servicing in AU/NZ conditions, it’s smart to inspect bushes every 20,000 km or annually. Many last 100,000–160,000 km, but cars that see rough roads, heavy loads or hot climates may need them sooner. Look for cracks, splits, perishing, oil-soaked rubber, or excessive arm movement with a pry bar. Front lower control arm rear bushes are common wear items on the P12, and subframe or rear link bushes can cause a dull thud and vague handling when worn.

When replacing, do both sides on the same axle for balance, and always get a wheel alignment afterward. Torque all fasteners at normal ride height to avoid pre-loading the new bushes. OE-style rubber keeps things quiet and comfy