Your Selected Vehicle
Parts for your 2004 Mitsubishi Pajero-Headlight bulbs
LED Autolamps 12/24V LED Reverse Lamp Screw Surface Mount Blister Pack - 12WM-2
LED Autolamps Multi Volt Stop/Tail/Indicator/Reverse Lamp 97 LEDs With Black Bracket - 200BARWM
LED Autolamps 174 Series Stop/Tail Lamp 12/24V, Surface Mount, 40cm Cable - 174RMB
LED Autolamps MultiVolt R.H.S Stop/Tail/Indicator Assembly 128 Round LEDs - 125BARMR
Explore 4WD & Adventure
LED Autolamps 12/24V Round Indicator Lamp With Clear Lens 130mm Diameter Recessed Mount - 102ACM
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly 3 Lamps With 153 LEDs - 125BARWM
LED Autolamps 12/24V LED Stop/Tail/Indicator Light 284x100x27mm Blister Pack - 282ARRM
LED Autolamps Twin function rear position with supplementary rear indicator - 97CRIM
LED Autolamps 12/24 Multi Volt Stop/Tail/Indicator/Reverse Assembly Lamp With 108 LEDs - 80BARWM
LED Autolamps Twin function front position with supplementary front indicator - 97WIM
LED Autolamps RHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284RHS
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly With 123 LEDs - 100BARWM
LED Autolamps 12V Stop/Tail/Indicator/Reverse Assembly Chrome Bracket Blister Pack - 82CARRW
LED Autolamps Front End Outline Marker White 12/24Vwith 2P plugs 10cm cable - 58WMB2P
LED Autolamps 10/30V Front Outline Position Marker 4 White LEDs With 40cm Wire - 35WM
LED Autolamps Twin function side indicator with amber/red side marker - 97ARIMB
LED Autolamps 12V LED Stop/Tail/Indicator/Reverse Assemnly Lamp With 108 LEDs - 80BARW
2004 Mitsubishi Pajero headlight bulbs
Headlight bulbs absolutely are used on the 2004 Mitsubishi Pajero (NP series). Technical references including the Mitsubishi Pajero 2004 Owner’s Manual (lighting section), the Mitsubishi ASA/EPC parts catalogue, and major bulb makers’ fitment guides confirm halogen headlamp bulbs were factory-fit. Most AU/NZ Pajero variants use an H4 12V 60/55W dual‑filament bulb for combined low/high beam, some higher-spec trims may run separate bulbs (HB4/9006 low beam and HB3/9005 high beam). So yes—headlight bulbs are relevant service items on this model.
On a tough tourer like the Pajero, headlight bulbs do the heavy lifting once the sun’s down—delivering a safe, legal beam pattern so the road, roos, and ruts stay visible. Over time, halogen filaments wear, light output declines, and lenses haze, so keeping the front end bright is part of sensible servicing.
Good practice for replacement and maintenance:
- Identify the correct type: usually H4, some trims use HB3/HB4. Confirm via the owner’s manual, the under‑bonnet label, or VIN‑based parts lookup.
- Replace in pairs. Ageing bulbs go yellow and dim—new bulbs on both sides keep colour and brightness even.
- Avoid touching the glass. Oils from fingers cause hot spots and shorten life. Use gloves or a clean tissue.
- Check fuses, connectors, and earths if a lamp is out. Corrosion at the plug or a tired relay can mimic a bad bulb.
- Aim the headlights after fitting. Proper alignment prevents glare and makes the most of your beam on country roads.
- Keep lenses clear. Wash with car shampoo and, if they’re cloudy, consider a UV-stable restoration kit.
- Choose quality globes. ADR-compliant +30/+50/+100 “performance” halogens can lift reach, but they may have shorter life—ideal for night touring, with a spare set kept in the glovebox.
- Be mindful of legality. LED or HID retrofits into halogen housings are commonly not ADR/WOF compliant in AU/NZ unless the entire assembly is certified for that light source.
For most owners, a fresh pair of H4s every few years, tidy connectors, and correctly aimed lamps will keep the Pajero lighting up the track like it should. If the model uses separate HB3/HB4 bulbs, the same tips apply—just match the exact types and wattage.
Popular questions about 2004 Mitsubishi Pajero headlight bulbs
What bulb type fits a 2004 Pajero?
Most AU/NZ 2004 Pajero NP models take an H4 12V 60/55W bulb for both low and high beam. Some higher-spec variants use HB4 (9006) for low beam and HB3 (9005) for high beam. The sure-fire way is to check the owner’s manual or the part label behind the headlamp and match the VIN in a parts catalogue.
Can I upgrade to LED or HID bulbs?
Only if the headlamp assembly is designed and certified for that light source. Dropping LED or HID bulbs into a halogen housing will usually fail ADR/WOF compliance and can cause glare. If you want more light, choose premium ADR-compliant halogen globes and ensure the aim and lenses are spot on.
How often should I replace them?
Halogen bulbs typically last 2–4 years, but performance ones trade life for brightness. Replace in pairs when you notice a dimmer, yellower beam, a flicker, or if one fails. Touring? Carry a spare set so you’re not stuck after dark.