Parts for your 2003 Nissan Serena-Driveshafts

2003 Nissan Serena driveshafts — what they do and how to look after them

Driveshafts are absolutely relevant on the 2003 Nissan Serena (C24). Technical references including the Nissan Serena C24 Service Manual (Driveline & Axle section), the Nissan FAST parts catalogue, and common parts listings for this model show front CV driveshafts (half‑shafts) on all FWD variants, with 4WD models also using a propeller shaft to the rear diff plus rear driveshafts. So if a 2003 Serena’s moving under its own steam, it’s using driveshafts to get torque to the wheels.

On the FWD Serena, each front driveshaft connects the transaxle to a wheel hub, with constant velocity (CV) joints at both ends. Those CV joints let the wheels steer and move up and down while still putting power down smoothly. On 4WD versions, there’s also a prop shaft running down the centre to a rear differential, and short rear shafts to each rear wheel.

For everyday servicing, it’s worth a quick look at the CV boots and clamps every service or 10,000–15,000 km. If a boot’s torn or weeping grease, sort it early — a fresh boot and grease is much cheaper than a whole shaft. Typical warning signs include:

• Clicking or popping on full lock (front CV joints)
• Vibration or shudder under acceleration
• Grease sprayed around the inner guard or chassis
• Droning/rumbling from underneath on 4WD (prop shaft centre bearing or U‑joint play)

When replacement’s on the cards, many owners go for complete exchange shafts for simplicity. Boot‑only repairs are fine if the joint hasn’t run dry or ingested grit. Always use quality moly CV grease and proper stainless clamps. For 4WD, also check the prop shaft universal joints and centre support bearing while you’re there.

Practical tips a mechanic will follow on a Serena:

• Use a new staked hub nut and stake it correctly on reassembly
• Expect a small loss of transaxle fluid when removing a front shaft