Parts for your 2002 Nissan Pulsar-Driveshafts

2002 Nissan Pulsar driveshafts — what they do and how to look after them

Yes, driveshafts are absolutely relevant to a 2002 Nissan Pulsar (N16). Technical references including the Nissan Pulsar/Almera N16 Factory Service Manual (Front Axle/Driveshaft sections) and the Nissan FAST parts catalogue list front driveshaft (CV axle) assemblies for this model, confirming it’s front‑wheel drive with a left and right front driveshaft and no rear prop shaft. Aftermarket catalogues for the N16 in Australia and New Zealand also list complete CV shafts, outer/inner CV joints and boot kits for 2000–2005 Pulsar models, further backing this up.

On the 2002 Pulsar, the driveshafts (often called CV shafts or half‑shafts) transfer power from the transaxle to the front wheels while allowing the suspension to move and the wheels to steer. Each shaft uses constant‑velocity joints at the inner and outer ends, packed with grease and protected by rubber boots. Keep those boots healthy and the shafts usually clock up years of service without a fuss.

As part of routine servicing, it’s smart to pop the bonnet, get the front end safely up, and inspect the CV boots every service or 10,000–15,000 kilometres. Look for splits, cracks, loose clamps or grease flung around the inside of the wheel or guard. Catching a torn boot early means a cheap boot kit, fresh grease and new clamps