Your Selected Vehicle
Parts for your 2002 Nissan Navara-Headlight bulbs
LED Autolamps 12/24 Multi Volt Stop/Tail/Indicator/Reverse Assembly Lamp With 108 LEDs - 80BARWM
LED Autolamps Multi Volt Stop/Tail/Indicator/Reverse Lamp 97 LEDs With Black Bracket - 200BARWM
LED Autolamps 12/24V Reversing Lamp With 25 White LEDs With Bracket and 30cm Wire - 100WM
LED Autolamps Front Marker LED White With Reflector 12-24V Perm Mnt - EU38WMHD
Explore 4WD & Adventure
LED Autolamps 10/30V Front Outline Position Marker 4 White LEDs With 40cm Wire - 35WM
LED Autolamps 12V Stop/Tail/Indicator/Reverse Assembly Chrome Bracket Blister Pack - 82CARRW
LED Autolamps Front End Outline Marker White 12/24Vwith 2P plugs 10cm cable - 58WMB2P
LED Autolamps 12/24V Round Indicator Lamp With Clear Lens 130mm Diameter Recessed Mount - 102ACM
LED Autolamps MultiVolt R.H.S Stop/Tail/Indicator Assembly 128 Round LEDs - 125BARMR
LED Autolamps Twin function side indicator with amber/red side marker - 97ARIMB
LED Autolamps 12V LED Stop/Tail/Indicator/Reverse Assemnly Lamp With 108 LEDs - 80BARW
LED Autolamps Twin function rear position with supplementary rear indicator - 97RIMB
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly With 123 LEDs - 100BARWM
LED Autolamps Multi Volt LED Licence Plate Lamp With Chrome Base Twin Blister - 30CLM
LED Autolamps RHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284RHS
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly 3 Lamps With 153 LEDs - 125BARWM
LED Autolamps 12/24V LED Stop/Tail/Indicator Light 284x100x27mm Blister Pack - 282ARRM
LED Autolamps Twin function rear position with supplementary rear indicator - 97CRIM
LED Autolamps Twin function front position with supplementary front indicator - 97WIM
2002 Nissan Navara headlight-bulbs — what they do and how to look after them
Headlight-bulbs are absolutely relevant and fitted on the 2002 Nissan Navara (D22). Technical sources including the 2002 Navara/D22 Owner’s Manual and the Nissan Factory Service Manual (FSM) — Lighting section — specify halogen headlamp bulbs. Most D22 variants use H4 12V 60/55W dual‑filament bulbs for low and high beam in a single globe, some trims with separate high beam list H1 12V 55W for the high beam. Market and trim can vary, so the bulb type is also moulded on the lamp housing (e.g., “H4”).
On this Navara, the headlight-bulbs handle the heavy lifting for safe night and low‑light driving, throwing a legal, well‑shaped beam onto the road and kerbside. They help the ute be seen in rain, fog and dawn/dusk, and keep it compliant with roadworthiness checks like WOF/regos under AU/NZ rules. Being halogen, they’re designed for stable colour and output when supplied with proper system voltage, and they sit behind a dust boot to keep moisture and grit out of the reflector.
During regular servicing, it’s smart to check brightness, beam aim, lens clarity and the condition of the connectors and dust boots. Halogen bulbs gradually dim with age, so if one fails or looks tired, replacing both sides keeps the light pattern even. Avoid touching the glass — skin oils can shorten bulb life. Stick with the specified wattage to protect the wiring and reflectors, going higher without dedicated relays and certified housings can cause heat damage and glare.
- Confirm bulb spec: typically H4 60/55W, some models use H1 for high beam. Check the owner’s manual, FSM, or the lamp housing marking.
- Access from behind the headlamp: disconnect the connector, peel back the rubber dust boot, then release the spring clip.
- Remove the old bulb, note the tab orientation, and fit the new bulb without touching the glass. If touched, clean with isopropyl alcohol.
- Refit the clip and dust boot, reconnect the plug, and repeat on the other side.
- Test low and high beam, then check beam aim using the adjusters, aim should meet ADR/WOF guidelines.
- Inspect lenses for haze, consider a proper restoration if the polycarbonate is cloudy to restore output.
Popular question: What headlight-bulb fits a 2002 Nissan Navara?
Most D22 Navaras run an H4 12V 60/55W halogen for combined low/high beam. Some trims with separate high beam use H1 55W for high. The exact type is in the owner’s manual and stamped on the lamp housing.
Popular question: How often should headlight-bulbs be replaced?
Replace when dim, colour‑shifted, or failed. Halogen bulbs can lose output over 2–3 years of typical use, so changing in pairs keeps the beam balanced and bright.
Popular question: Can LED bulbs be used instead?
Retrofitting LED bulbs into halogen housings may not meet ADR/WOF requirements and can cause glare if the optics aren’t designed for LEDs. If considering LEDs, use components that are properly tested and certified for road use in AU/NZ.