Your Selected Vehicle
Parts for your 2002 Nissan Bluebird-Headlights
LED Autolamps 12V Stop/Tail/Indicator/Licence Plate Lamp With Reflector - 149BARL4P
LED Autolamps Multi Volt Stop/Tail/Indicator Lamp With Reflex Reflectors Grey Base Blister Pack 1 pce - 100ARM
Explore 4WD & Adventure
LED Autolamps 174 Series Stop/Tail/Indicator Lamp 12/24V, Surface Mount, 40cm Cable - 174ARMB
LED Autolamps 174 Series Reverse Lamp 12/24V, Surface Mount, 40cm Cable - 174WMB
LED Autolamps 174 Series Stop/Tail Lamp 12/24V, Surface Mount, 40cm Cable - 174RMB
LED Autolamps 12V Stop/Tail Lamp Black Chrome Round With Clear Lens - 102RBC
LED Autolamps 10/30V LED Side Direction Indicator Light With 30cm Wire - 35AMB
LED Autolamps 12/24V Round Stop/Tail Lamp With Clear Lens 130mm Diameter Recessed Mount Blister Pack - 102RCM
LED Autolamps Licence Plate Lamp Black Bracket Multi Volt With 1m Cable - 35BLM1P
LED Autolamps 12V Front Indicator Amber Lens Black Base Twin Blister Pack - 175A/2
LED Autolamps LHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284LHS
LED Autolamps 12/24V Reversing Lamp With 25 White LEDs With Bracket and 30cm Wire - 100WM
LED Autolamps 12V 82 Series Stop/Tail/Indicator/Reverse Lamp Black Bracket - 82BARW
LED Autolamps 12/24 Multi Volt Stop/Tail/Indicator/Reverse Assembly Lamp With 108 LEDs - 80BARWM
LED Autolamps 12/24V LED Reverse Lamp Screw Surface Mount Blister Pack - 12WM-2
2002 Nissan Bluebird Headlights — Purpose, Care and Replacement
Headlights are absolutely fitted and relevant on the 2002 Nissan Bluebird. Factory documentation such as the 2002 Nissan Bluebird/Bluebird Sylphy owner’s manual and Nissan parts catalogues (e.g., Nissan FAST), along with regulatory lighting requirements in Australia and New Zealand (ADR 13/00, NZTA Warrant of Fitness standards), all confirm the vehicle is equipped with halogen headlamps. Most 2002 Bluebird and Bluebird Sylphy trims use dual‑filament H4 60/55 W bulbs in reflector housings. So, yes—this model relies on its headlights for safe, legal night and low‑visibility driving.
On this Bluebird, the headlights do the heavy lifting after dark: they light the road ahead, make the car visible to others, and provide a crisp high beam for country drives. Properly aimed and clear lenses help the driver spot hazards sooner without dazzling oncoming traffic. That’s not just convenient—it’s required for roadworthiness inspections in Aus and NZ, and it keeps the car compliant with local lighting standards.
As part of regular servicing, a quick headlight check pays off. Bulbs fade before they fail, so if night vision feels a bit dull, it might be time for fresh H4s in pairs to keep both sides evenly bright. Keep lenses clean and clear, yellowing or haze reduces output and can be restored with a reputable UV‑stable kit. If there’s moisture inside the housing, the rear cap or vent may need attention. When replacing bulbs, avoid touching the glass (use gloves), seat the bulb fully, refit the dust cap, and confirm aim on level ground. After any front‑end work, have the beam aim checked, as small knocks can nudge the adjusters and create glare.
- Signs it’s time to act: dim or patchy light, yellowed lenses, moisture in the housing, or a failed WOF/roadworthy for headlamp aim.
- Fit quality, ADR/NZ‑compliant bulbs, upgrade options are fine if they’re legal and don’t exceed rated wattage.
- Use dielectric grease on connectors if they’re corroding, inspect the headlamp fuse and relay if both sides go out.
Popular question: What bulb type fits a 2002 Nissan Bluebird?
Most 2002 Bluebird/Bluebird Sylphy variants use an H4 60/55 W halogen for combined low/high beam in a reflector housing. Some market trims can differ, so it’s smart to confirm via the owner’s manual, the under‑bonnet bulb chart, or a parts lookup by VIN. Replace bulbs in pairs to keep colour and brightness even.
Popular question: How do you adjust the headlight aim?
Park on level ground facing a wall at about 3–5 metres, with normal tyre pressure and fuel. Mark the current beam cutoff, then use the vertical and horizontal adjusters on the back of each lamp to set the cutoff just below head height at the wall and centred to the vehicle. If unsure, have a workshop align them with a beam setter to meet ADR/NZTA specs.
Popular question: Why is there condensation in the headlight?
Light fogging after rain can be normal as air moves through the lamp vents, but persistent droplets mean a compromised seal or rear dust cap. Dry the housing by removing the cap in a warm, dry place, then check the gasket, vent and cap fit. If the lens or housing is cracked, replacement is usually the lasting fix.