Your Selected Vehicle
Parts for your 2002 Honda Odyssey-Tail lights
LED Autolamps 12V LED Stop/Tail/Indicator/Reverse Assemnly Lamp With 108 LEDs - 80BARW
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly 3 Lamps With 153 LEDs - 125BARWM
LED Autolamps 12V Stop/Tail/Indicator Assembly 3 Lamps With 108 LEDs Black Bracket - 80BARR
LED Autolamps 12V Stop/Tail/Indicator Lamp With Reflex Reflector 100x100x25mm - 100BAR
LED Autolamps Multi Volt Stop/Tail/Indicator Lamp 190x95x28mm Blister Pack - 280ARM
Explore 4WD & Adventure
LED Autolamps 12V Stop/Tail/Indicator/Reverse With Reflectors And 500mm LP Cable - SO283ARWM2LR12
LED Autolamps Multi Volt Stop/Tail/Indicator Assembly 72 LEDs With Black Bracket - 200BARM
LED Autolamps 355 Series Multi Volt Black Stop/Tail/Indicator/Reverse/Reflector LHS & RHS Twin Blister Pack - 355BARWM-2
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse/Reflector Mini Jumbo Twin Blister - 420ARRWM2
LED Autolamps Multi Volt Stop/Tail/Indicator Assembly 72 LEDs With Black Bracket 190x100x28mm - 80BARM
LED Autolamps Multi Volt Stop/Tail/Indicator With 18 Square LEDs Twin Blister - 135ARM/2
LED Autolamps 12V Stop/Tail/Indicator/Reverse Assembly Chrome Bracket Blister Pack - 82CARRW
LED Autolamps MultiVolt R.H.S Stop/Tail/Indicator Assembly 128 Round LEDs - 125BARMR
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly With 123 LEDs - 100BARWM
LED Autolamps LHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284LHS
LED Autolamps 12/2V Maxilamp LED Stop/Tail/Indicator/Reflector Black Chrome Bolt Mount - MAXILAMPC1XCE
LED Autolamps RHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284RHS
LED Autolamps 385 Series Rear Combination Lamp LHS with 7 core plug - 385ARWMLCSB
LED Autolamps 385 Series Rear Combination Lamp RHS with 7 core plug - 385ARWMRCSB
LED Autolamps 12/24V Rear Indicator Light With Amber Lens Blister Pack - 113AMG
2002 Honda Odyssey tail-lights — purpose, care, and easy servicing tips
Tail-lights are absolutely fitted and relevant to the 2002 Honda Odyssey. This is supported by Honda’s 2002 Odyssey Owner’s Manual and Service Manual, which detail rear combination lamp functions and bulb replacement. Regulatory requirements in Australia and New Zealand also mandate rear position lamps on passenger vehicles (Australian Design Rules 13/00 and 49/00, NZ Land Transport Rule: Vehicle Lighting 2004), reinforcing that the Odyssey must be equipped with functioning tail-lights.
The tail-lights on a 2002 Odyssey do a lot more than just glow red at night. They mark the van’s presence and width after dark or in rain and fog, and they share housing with the brake, indicator, and reverse lamps to keep everyone on the road clued in. Honda designed the rear combination lamps to be serviceable, so owners can swap bulbs and keep the lenses clear without drama.
For regular servicing, a quick visual check is gold. Switch on the lights, get a mate to stand behind, and confirm both tail-lights illuminate evenly. Tap the brake, select reverse (with the engine off and ignition on), and run the indicators. If a lamp is out or dim, it’s often just a spent bulb or a dodgy contact.
Replacement is straightforward: open the tailgate, remove the retaining fasteners for the rear lamp assembly, slide the unit straight back, and twist the bulb holders to access the bulbs. Fit quality bulbs of the correct spec listed in the owner’s manual, and consider replacing in pairs so brightness matches side to side. A light smear of dielectric grease on the socket terminals helps ward off corrosion, especially in coastal areas.
Keep the lenses clean with mild car shampoo—avoid harsh solvents that can haze the plastic. If there’s moisture inside the lens, check the gasket and mounting points, reseat or replace the seal to stop water sneaking back in. If multiple rear lights fail at once, check the relevant fuse in the cabin fuse panel before digging deeper.
- Test lights monthly, and before long trips.
- Use ADR/E-mark compliant bulbs or approved LED retrofits where legal.
- If indicators blink fast after an LED upgrade, you may need load resistors or an appropriate flasher unit.
Staying on top of tail-light maintenance not only keeps the Odyssey looking tidy—it helps it pass WOF/roadworthy checks and keeps the family safer on every night drive.
What bulb types fit the 2002 Odyssey’s tail-lights?
The rear combination lamps typically use dual-filament wedge bulbs for tail/stop and single-filament bulbs for indicators and reverse. Exact part numbers can vary by market, so check the 2002 Honda Odyssey Owner’s Manual or the bulb chart on the lamp housing to match the correct specs.
Can I upgrade the Odyssey’s tail-lights to LEDs?
Yes, many owners fit LED replacements for better brightness and longevity. Make sure the LEDs comply with ADR/NZ lighting rules and maintain correct colour and intensity. You may need resistors or a compatible flasher relay to avoid hyper-flash on indicators.
Why is there moisture in the tail-light, and is it a fail?
Light condensation can occur with temperature swings, but persistent water droplets suggest a compromised seal or cracked lens. Reseal or replace the gasket, and inspect mounting points. Excess moisture can dull output and may trigger a WOF/roadworthy fail if it affects lamp performance.