Your Selected Vehicle
Parts for your 2001 Nissan Serena-Headlights
LED Autolamps 12V Stop/Tail/Indicator/Licence Plate Lamp With Reflector - 149BARL4P
LED Autolamps Multi Volt Stop/Tail/Indicator Lamp With Reflex Reflectors Grey Base Blister Pack 1 pce - 100ARM
Explore 4WD & Adventure
LED Autolamps 174 Series Stop/Tail/Indicator Lamp 12/24V, Surface Mount, 40cm Cable - 174ARMB
LED Autolamps 174 Series Reverse Lamp 12/24V, Surface Mount, 40cm Cable - 174WMB
LED Autolamps 174 Series Stop/Tail Lamp 12/24V, Surface Mount, 40cm Cable - 174RMB
LED Autolamps 12V Stop/Tail Lamp Black Chrome Round With Clear Lens - 102RBC
LED Autolamps 10/30V LED Side Direction Indicator Light With 30cm Wire - 35AMB
LED Autolamps 12/24V Round Stop/Tail Lamp With Clear Lens 130mm Diameter Recessed Mount Blister Pack - 102RCM
LED Autolamps Licence Plate Lamp Black Bracket Multi Volt With 1m Cable - 35BLM1P
LED Autolamps 12V Front Indicator Amber Lens Black Base Twin Blister Pack - 175A/2
LED Autolamps LHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284LHS
LED Autolamps 12/24V Reversing Lamp With 25 White LEDs With Bracket and 30cm Wire - 100WM
LED Autolamps 12V 82 Series Stop/Tail/Indicator/Reverse Lamp Black Bracket - 82BARW
LED Autolamps 12/24 Multi Volt Stop/Tail/Indicator/Reverse Assembly Lamp With 108 LEDs - 80BARWM
LED Autolamps 12/24V LED Reverse Lamp Screw Surface Mount Blister Pack - 12WM-2
2001 Nissan Serena Headlights
Headlights are absolutely relevant and factory‑fitted on the 2001 Nissan Serena (C24). This is confirmed in the Nissan Serena C24 owner’s manual and service literature for the lighting and electrical (EL) sections, and is mandated for on‑road use under Australian Design Rule ADR 13/00 and the NZ Land Transport Rule: Vehicle Lighting 2004. So yes—this Serena runs proper headlamps, and they’re a vital safety item, not an optional extra.
On the 2001 Serena, the headlights provide the forward illumination needed for night and low‑visibility driving while also making the vehicle visible to others. Most markets received halogen reflector units—commonly dual‑filament H4 60/55W bulbs, though some trims used separate high/low beams (e.g., H7/H1). Either way, they’re designed to meet beam pattern and glare limits set by ECE/ADR standards, so keeping them in good nick matters for safety and compliance.
As part of regular servicing, it’s smart to check beam aim, lens clarity, and bulb condition. If a bulb’s out, replace in pairs to keep brightness and colour consistent. Aim tends to creep after potholes or front‑end work, so a quick alignment helps avoid glare and keeps the cutoff where it should be.
- Bulb checks and swaps: Allow the lamps to cool, disconnect the connector, release the spring clip, and note the bulb type stamped on the base. Avoid touching the glass—use gloves or a tissue.
- Lens care: If the lenses are hazy or yellowed, a quality UV‑resistant restoration kit can sharpen the beam and extend lens life.
- Electrical basics: If both lights go out, inspect the headlamp fuses and the relevant relay in the engine‑bay fuse box. For a single side, suspect the bulb or connector.
- Aim adjustment: Park on level ground facing a wall about 7.5 m away. Use the vertical and horizontal adjusters to set a clean, level cutoff at the recommended height per ADR/NZ guidance or workshop specs.
- Upgrades: LED or HID retrofits in halogen housings may not be road‑legal unless specifically approved and properly aimed. Always check local rules before changing technologies.
For everyday reliability, include headlight checks in each service or every 10,000 km, and before long night drives. A few minutes in the driveway can save a defect notice—and make those winter nights far easier on the eyes.
Popular questions
What bulb type does a 2001 Nissan Serena use?
Many 2001 Serena C24 models use H4 60/55W halogen bulbs, but some trims run separate high/low beams such as H7 low and H1 high. The easiest way to be sure is to check the owner’s manual, read the code on the existing bulb, or reference the vehicle’s build plate and parts catalogue.
How do you adjust the headlight aim on a 2001 Serena?
Park on level ground 7.5 m from a wall, measure lamp centre height, and set the cutoff slightly below that line according to ADR/NZ guidance. Use the adjuster screws on the headlamp housing for vertical and horizontal tweaks. If unsure, a workshop beam setter will nail it quickly.
Are LED replacement bulbs legal in Australia or NZ for this model?
Generally, swapping halogen bulbs for aftermarket LEDs in halogen reflectors isn’t road‑legal unless the bulbs and assembly are certified and accepted locally. Check ADR and NZ WOF requirements before fitting, and ensure the beam pattern doesn’t cause glare.