Parts for your 2000 Daihatsu Yrv-Headlights

2000 Daihatsu YRV Headlights

Headlights are absolutely relevant and fitted to the 2000 Daihatsu YRV. This is supported by the Daihatsu YRV owner’s manual (2000) which covers lighting controls and bulb replacement, the Daihatsu electronic parts catalogue for J102/J112 models listing headlamp assemblies and halogen bulbs, and road-legality requirements in Australia and New Zealand via ADR 13/00 and ADR 46/00 (and equivalent ECE R48) that mandate primary headlamps on passenger vehicles.

On the 2000 YRV, the headlights do the heavy lifting after dark and in poor weather—throwing a clean low beam for everyday use and a high beam for open-road visibility. It’s a halogen reflector setup in most markets, commonly running an H4 12V 60/55W dual‑filament bulb. Some trims also have a manual levelling dial to keep the beam tidy when the car’s loaded.

For servicing, it’s smart to check headlight operation at every service interval. Look for dull or yellow light, flickering, water or condensation inside the lens, or cloudy plastic. A quick clean with a pH‑neutral wash helps, if the lenses are hazed, a proper restoration kit with a UV sealant can bring back clarity. If a bulb’s blown, replace both sides together to keep colour and brightness even, and only use ADR/E‑marked quality bulbs. Avoid touching the glass—use gloves or a tissue so oils from fingers don’t shorten bulb life.

Electrical checks matter too. If the lights seem dim, test for voltage drop at the headlight connector, and inspect fuses, the headlight relay, and earth points. After any bulb or housing change, re-check the aim. On level ground facing a wall, the cut-off should sit slightly below headlight height at a few metres, use the adjusters and follow the handbook spec. If you’re not confident, any workshop can set it spot-on.

1. Switch the lights off and let the bulb cool.
2. Open the bonnet, unplug the connector, remove the rubber boot, then unclip the spring.
3. Fit the new H4 bulb in the same orientation, clip it in, refit the boot, and reconnect.
4. Test low and high beam, then check aim.

Thinking of LED retrofits? Be cautious. Swapping LED bulbs into halogen housings can be non-compliant and may fail a WOF/roadworthy unless the parts are specifically approved to the relevant ADR/ECE standards.

Popular questions

What headlight bulb does a 2000 Daihatsu YRV use?
Most 2000 YRV models use an H4 12V 60/55W halogen bulb for both low and high beam in a reflector housing. Always confirm against the vehicle handbook or a bulb chart for your VIN. Fog lamps, where fitted, may use a different type (often H3).

How do you adjust the headlight aim on a YRV?
Park on level ground about 5 metres from a wall, measure headlight centre height, and set the cut-off a little lower on the wall. Use the vertical and horizontal adjusters on the lamp. For perfect results that meet WOF/roadworthy expectations, have a workshop set it with a beam setter.

Are LED headlight conversions legal on a 2000 YRV?
Generally, LED bulbs in halogen headlamp units aren’t road-legal in AU/NZ unless the assembly or replacement parts are certified to the applicable ADR/ECE standards. Non-compliant conversions can cause glare and may fail inspection—stick with approved components.