Your Selected Vehicle
Parts for your 2000 Daihatsu Yrv-Headlight bulbs
LED Autolamps 12V Stop/Tail/Indicator Lamp With Reflex Reflector 100x100x25mm - 100BAR
LED Autolamps Rear End Outline LED Marker Red 12/24v Red Lens 16cm Cable Blister Pack - 42RM
LED Autolamps Twin function front position with supplementary front indicator - 97CWIMB
LED Autolamps Multi Volt Indicator Lamp With Clear Lens And Chrome Reflector Blister Pack - 131CAM
LED Autolamps Twin Function Stalk Side Indicator With Red/Amber Side Marker LHS Multivolt - 805ARIML
LED Autolamps 12/24V Reverse Light 200x50mm With 25 LEDs Black Bracket - 200BWM
Explore 4WD & Adventure
LED Autolamps 12/24V Rear Indicator Light With Amber Lens Blister Pack - 113AMG
LED Autolamps Twin function front position with supplementary front indicator - 97CWIM
LED Autolamps 12/24V Rear Indicator Lamp Red Reflector Blister Pack - 460AM
LED Autolamps Red LED Stop/Tail Lamp Insert For J3 Series Blister Pack - J3RM
LED Autolamps Amber LED Indicator Lamp Insert For J3 Series Blister Pack - J3AM
LED Autolamps Twin function side indicator with amber/red side marker - 97ARIM
LED Autolamps Twin function rear position with supplementary rear indicator - 97RIMB
LED Autolamps 10/30V Chrome Series LED Red Amber Side Marker With 40cm Wire - 35CCARM
LED Autolamps Twin function side indicator with amber/red side marker - 97CARIM
2000 Daihatsu YRV headlight bulbs – what they do and how to look after them
Headlight bulbs are absolutely relevant to the 2000 Daihatsu YRV. Technical sources such as the Daihatsu YRV (M200) owner’s manual and major bulb fitment catalogues from Philips and OSRAM list halogen headlight bulbs for this model, typically the H4 dual‑filament type (12V 60/55W, P43t base). That means the YRV uses replaceable bulbs for both low and high beam within the headlamp unit, not sealed beams or dedicated LEDs.
On a 2000 YRV, the headlight bulb’s job is simple: provide reliable low and high beam so the driver can see and be seen, day and night, in all sorts of Kiwi and Aussie conditions. Over time, halogen bulbs dim and their colour shifts, so even if they haven’t blown, output can drop off noticeably. Replacing them in pairs keeps the beam pattern and brightness balanced across both sides.
For routine servicing, a quick headlight check is a must. If the lights look dull or yellowed, or one side flickers, it’s time for new bulbs. Stick to the specified H4 rating and ADR/NZTA‑compliant parts. Avoid higher‑wattage “off‑road” bulbs that can overheat wiring and lenses. If considering LED conversions in a halogen housing, be aware these are often not road‑legal without proper certification and can cause glare if the beam pattern isn’t correct.
DIY replacement is straightforward on most YRV variants:
- Open the bonnet and locate the headlamp rear cover (rubber cap or plastic lid).
- Unplug the 3‑pin connector, release the spring clip, and withdraw the old H4 bulb.
- Install the new bulb with the locating tabs aligned. Don’t touch the glass, use gloves.
- Secure the clip, refit the cover, reconnect, then test low and high beam.
While you’re there, inspect the connector for heat damage, make sure the dust cap seals properly, and clean the outer lens. After any bulb change or if the light unit has been disturbed, check headlight aim so you’re lighting the road, not the trees or oncoming traffic.
A fresh set of quality H4 bulbs brings the YRV’s lighting back to its best—handy for early winter sunsets and wet highways alike.
Popular questions about 2000 Daihatsu YRV headlight bulbs
What bulb type fits the 2000 Daihatsu YRV headlights?
Most 2000 YRV (M200) models use H4 dual‑filament halogen bulbs (12V 60/55W, P43t base) for combined low and high beam, as listed in the owner’s manual and major bulb catalogues. Always check the vehicle handbook or the existing bulb markings to confirm before buying.
Are LED upgrades legal for the YRV’s headlights in Australia or New Zealand?
LED retrofits in halogen reflector housings are often not road‑legal unless specifically approved and compliant with ADR/NZTA rules. Even when they fit, many create poor beam patterns and glare. If road use is the goal, stick with approved halogen H4s or consult a licensed certifier.
How often should the bulbs be replaced?
There’s no fixed schedule, but halogens typically fade over 2–4 years of normal use. Replace immediately if a bulb fails, and consider changing both sides together for even brightness. If night vision feels worse or the light looks very yellow, a proactive refresh helps.