Your Selected Vehicle
Parts for your 2000 Daihatsu Yrv-Batteries
Narva 9-33 Volt Surface Mount LED rear end outline marker lamp(red) with Black cover and 0.5m cable - 96832B
Narva Model 63 Front End Outline Marker, Side Indicator (Amber) Or External Cabin Marker Lamp Black Base And 0.5M Cable
Explore 4WD & Adventure
Narva Model 70 Rear Stop/Tail /Indicator Lamp With In-Built Retro Reflector, With 0.5M Of Cable And Dt Plug - 97000-1-D
Narva 9-33 Volt LED Rear Stop/Tail and direcion indicator and reverse lamp with in built retro reflector and 0.5m hard wired cable - 97310
Narva MDL38 Stop/Tail/Indicator Red-Amber Lens LED 10 to 30V - 2 Pce - 93812BL2
Narva Model 70 Rear Stop/Tail/Indicator/Reverse Lamp With In-Built Retro Reflector, With 0.5M Of Cable, Bulk Pack Of 4 - 97010-1/4
Narva 9-33 Volt LED Rear Stop/Tail, Left Hand Squential direcion indicator and reverse lamps with in built retro reflector and 0.5m hard wired cable - 97312L
Narva 9-33 Volt Surface Mount LED Side directional indicator(amber) with Black cover and 0.5m cable - 96842B
Narva Model 18 LED Side Marker/Cabin Marker/FEOM Light Amber 10-30V - 91800
Narva 9-33 Volt Surface Mount LED Side marker lamp(red/amber) with Chrome cover and 0.5m cable - 96802
2000 Daihatsu YRV batteries: purpose, care and replacement
Yes, the 2000 Daihatsu YRV absolutely uses a 12‑volt starter battery. This is standard for petrol YRV models (K3-VE/K3-VET engines). Daihatsu service literature for the M2-series YRV and common fitment catalogues from battery makers (e.g., Yuasa and Exide ANZ) specify a conventional 12 V lead‑acid battery for cranking and powering vehicle electronics. There’s no variant of the 2000 YRV that deletes the battery, so it’s very much a relevant service item.
On this little tall-hatch, the battery’s job is to spin the starter, feed the ECU, fuel pump and ignition, and stabilise voltage for lights, wipers and accessories when the alternator isn’t keeping up. Once the engine’s running, the alternator takes most of the load and recharges the battery, but the battery still smooths spikes and supports sudden loads like the radiator fan and heater blower.
When replacing, owners will often see Japanese JIS case sizes such as B19 or B24 listed for the YRV, with left‑hand positive terminals. Capacity and cold‑cranking amps typically sit around 45–55 Ah and 330–450 CCA for Aussie and Kiwi conditions. Because trims and trays can vary, it’s smart to confirm polarity, hold‑down style, and dimensions under the bonnet, or match by VIN with a reputable fitment guide.
- Signs it’s tired: slow cranking, clicking on start, dim lights at idle, or random dash warnings.
- Basic checks: a healthy resting voltage is about 12.6 V, with the engine running you should see roughly 13.8–14.5 V at the terminals.
- Service tips: keep terminals clean and tight, neutralise corrosion with bicarb and water, and apply a smear of dielectric grease. If it’s a serviceable battery, only top up with distilled water.
- Replacement steps: save settings if needed, then remove negative (-) first, positive (+) second. Fit the new one, tighten the hold‑down, connect positive then negative, and check for secure clamps.
- Driving habits: lots of short trips can sulfate a battery, a longer weekend run helps. If the YRV sits for weeks, consider a smart maintainer.
- Lifespan and recycling: expect roughly 3–5 years depending on climate and use. Always recycle the old unit at a battery retailer or transfer station.
For turbo variants or colder regions, choosing a unit with a little extra CCA can aid cold starts and accessory loads without fuss.
Popular questions about 2000 Daihatsu YRV batteries
What battery type fits a 2000 Daihatsu YRV?
The YRV takes a 12 V lead‑acid starter battery, commonly in JIS B19 or B24 case sizes with left‑hand positive terminals. Look for around 45–55 Ah and 330–450 CCA for everyday use in Australia and New Zealand. Always check the tray size, clamp style and polarity under your bonnet, or confirm by VIN with a reputable fitment guide.
How long should the battery last in a YRV?
Typically 3–5 years. Hot summers, short trips, and high accessory use can shorten life. If cranking slows or lights dip at idle, get it load‑tested. A quick multimeter check (about 12.6 V at rest, 13.8–14.5 V charging) also gives a good health snapshot.
What tools do I need and what’s the safe replacement order?
Usually a 10 mm spanner for the clamps and a 10–12 mm for the hold‑down. Remove negative first, then positive, install positive first, then negative. Tighten the hold‑down so the battery can’t move, and recheck charging voltage after start. You may need to reset the clock and radio presets.