Your Selected Vehicle
Parts for your 1999 Toyota Hilux surf-Headlight bulbs
LED Autolamps 12/24 Multi Volt Stop/Tail/Indicator/Reverse Assembly Lamp With 108 LEDs - 80BARWM
LED Autolamps Multi Volt Stop/Tail/Indicator/Reverse Lamp 97 LEDs With Black Bracket - 200BARWM
LED Autolamps 12/24V Reversing Lamp With 25 White LEDs With Bracket and 30cm Wire - 100WM
LED Autolamps Front Marker LED White With Reflector 12-24V Perm Mnt - EU38WMHD
Explore 4WD & Adventure
LED Autolamps 10/30V Front Outline Position Marker 4 White LEDs With 40cm Wire - 35WM
LED Autolamps 12V Stop/Tail/Indicator/Reverse Assembly Chrome Bracket Blister Pack - 82CARRW
LED Autolamps Front End Outline Marker White 12/24Vwith 2P plugs 10cm cable - 58WMB2P
LED Autolamps 12/24V Round Indicator Lamp With Clear Lens 130mm Diameter Recessed Mount - 102ACM
LED Autolamps MultiVolt R.H.S Stop/Tail/Indicator Assembly 128 Round LEDs - 125BARMR
LED Autolamps Twin function side indicator with amber/red side marker - 97ARIMB
LED Autolamps 12V LED Stop/Tail/Indicator/Reverse Assemnly Lamp With 108 LEDs - 80BARW
LED Autolamps Twin function rear position with supplementary rear indicator - 97RIMB
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly With 123 LEDs - 100BARWM
LED Autolamps Multi Volt LED Licence Plate Lamp With Chrome Base Twin Blister - 30CLM
LED Autolamps RHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284RHS
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly 3 Lamps With 153 LEDs - 125BARWM
LED Autolamps 12/24V LED Stop/Tail/Indicator Light 284x100x27mm Blister Pack - 282ARRM
LED Autolamps Twin function rear position with supplementary rear indicator - 97CRIM
LED Autolamps Twin function front position with supplementary front indicator - 97WIM
1999 Toyota Hilux Surf headlight bulbs — what they do and how to look after them
Headlight bulbs are definitely used on the 1999 Toyota Hilux Surf. Toyota’s Electronic Parts Catalogue for the 185-series Surf (1999 MY) and the factory Repair Manual (Chassis & Body for RZN/VZN/KZN185) specify replaceable halogen bulbs in the headlamp assemblies. Depending on trim and headlamp style, the vehicle is typically fitted with either a dual‑filament H4 (60/55 W) bulb, or separate bulbs for high and low beam (HB3/9005 for high, HB4/9006 for low). That makes headlight bulbs directly relevant to servicing this model.
On a 1999 Hilux Surf, the headlight bulbs handle critical night-time visibility and help the vehicle meet ADR/NZTA lighting requirements. Bright, correctly aimed bulbs make a real difference on rural roads, in bad weather, and for WOF/RWC checks. If the lamps are the multi‑reflector type, expect two bulbs per side, if they’re a classic reflector, it’s commonly a single H4 per side. The exact type is stamped on the lamp housing and listed in the owner’s manual and Toyota EPC.
Replacement is straightforward and suits a weekend driveway job. Stick with reputable ADR‑compliant halogen bulbs in the correct wattage to avoid heat damage and glare. It’s smart to change bulbs in pairs so light colour and brightness match.
- Open the bonnet and locate the rear of the headlamp. Remove the rubber dust cap (if fitted).
- Unplug the connector and release the spring clip or twist-lock ring.
- Swap in the new bulb without touching the glass, use gloves or a clean tissue.
- Lock it in, refit the cap, reconnect, and test both beams.
- Check headlight aim on a level surface, adjust using the marked adjusters.
- Keep lenses clean and clear, oxidised lenses cut light output dramatically.
- If bulbs fail often, check charging voltage and earths, and look for moisture in the housing.
- A dab of dielectric grease on connectors helps fend off corrosion, especially near the coast or off-road.
- Avoid over‑wattage “rally” bulbs, they can overheat wiring and reflectors.
What bulb type fits a 1999 Hilux Surf?
Per Toyota’s EPC and factory manual, it’s commonly either H4 (60/55 W) for single‑reflector lamps, or HB4/9006 low beam and HB3/9005 high beam for multi‑reflector lamps. Check the marking on the headlamp housing or your owner’s manual to confirm.
Can LED or HID bulbs be used in the factory housings?
Retrofitting LED/HID into halogen housings may not comply with ADR/NZTA rules and can cause glare or a WOF/RWC fail. If upgrading, use approved kits with correct optics, or stick with quality halogen bulbs.
Why do my headlight bulbs keep blowing?
Common causes are vibration from rough roads, moisture in the housing, high charging voltage, touching the glass during install, or cheap bulbs. Check the alternator output, seals, and earth points, and use reputable bulbs.