Your Selected Vehicle
Parts for your 1999 Toyota Avensis-Tail lights
Repco 12V LED RearCombination Lamp Stop / Tail / Indicator / Licence Plate Pair 150x80x25mm - RLT150LBL2S3
LED Autolamps 12/24V Stop/Tail/Indicator Light Clear Lens Coloured LEDs Surface Mount - 12ARM-2
Explore 4WD & Adventure
LED Autolamps Rear combination L/R tail lights with sequential indicator, Chrome, Twin Blister - 355ARWM-2
Repco 12V LED Rear Combination Lamp Stop / Tail / Indicator / Licence Plate Pair 100x100x25mm - RLT100LBL2S3
LED Autolamps Multi Volt Stop/Tail/Indicator/Reverse/Reflector LHS & RHS Diffused Tail Light - 284ARWM-2
LED Autolamps 12/24V LED Rear Combination Stop/Tail/Indicator/Reverse Light with Reflectors, Blister Pack - 250ARWM
LED Autolamps 12/24V LED MaxiLamp Stop/Tail/Indicator/Reflector Light Round Blister Pack - MAXILAMP1XC
LED Autolamps 12V LED Boat Trailer Lamps Stop/Tail/Indicator with Licence Plate Lamp Light Left & Right Side, with 8m cable, Twin Blister - 209GARLP2/8M
1999 Toyota Avensis tail-lights: purpose, care and replacement
Tail-lights are absolutely fitted and relevant on the 1999 Toyota Avensis (T22). This is confirmed by the Toyota Avensis Owner’s Manual lighting section, the Toyota Electronic Parts Catalogue listing “Rear Combination Lamp” assemblies for the T22 series, and independent repair references such as the Haynes Toyota Avensis 1998–2003 manual. Their fitment also aligns with legal requirements like ECE Regulation No. 7 (rear position lamps) adopted in many markets, Australia’s ADR 13/00 installation rules, and New Zealand’s WOF (NZTA VIRM) lighting standards.
On a 1999 Avensis, the tail-lights do more than glow red at night. They mark the vehicle’s width, make it visible in low light and rain, and house the brake, indicator, and reverse functions within the same rear cluster. Most models of this era use replaceable globes, typically a dual‑filament 21/5 W bulb for stop/tail, with separate bulbs for indicators and reverse. The exact bulb spec can vary by market and trim, so it’s wise to check the owner’s manual or the stamp on the existing bulb before buying replacements.
As part of regular servicing, a quick tail-light check saves hassles at rego or WOF time and boosts safety on dark rural roads. Look for dullness, cracked lenses, condensation, or intermittent operation. If a bulb’s out, replacement is straightforward: open the boot, remove the access cover, undo the lamp fasteners, twist out the bulb holder, and swap like‑for‑like. Avoid touching glass with bare fingers—skin oils can shorten bulb life.
- Clean the lamp contacts and earth points