Parts for your 1999 Daihatsu Gran move-Tail lights

1999 Daihatsu Gran Move tail-lights

Tail-lights are absolutely fitted to the 1999 Daihatsu Gran Move (also sold as the Daihatsu Pyzar). Technical sources including the Daihatsu Gran Move/Pyzar owner’s and workshop manuals for the G303/G313 series describe rear combination lamps with tail (rear position) lamps, stop lamps, indicators and reverse lamps. This aligns with legal fitment requirements set by Australian Design Rules (ADR 13/00 Installation of Lighting, ADR 49 for position/stop lamps) and New Zealand’s Land Transport Rule: Vehicle Lighting 2004, which mandate operational rear position lamps on road vehicles of this class.

On the Gran Move, the tail-lights do the heavy lifting for night-time and low-visibility driving. They mark the back of the car so others can see it, brighten when braking, flash for indicating, and light up when reversing. The assembly is a simple, reliable setup, and when looked after, it keeps the Gran Move safe and legal on Aussie and Kiwi roads.

For routine servicing, it’s worth giving the rear lamps a once-over every six months or at each service:

• Check the lenses for cracks, fading or moisture buildup. A misty lens often means a perished gasket.
• Confirm all functions: tail, brake, indicator and reverse. Test with a mate or use reflections against a wall.
• Replace tired bulbs in pairs to keep brightness even. The Gran Move typically uses dual-filament bulbs for stop/tail in the rear combination lamp, confirm wattage and base type in the owner’s manual.
• Inspect the lamp seals and the boot-side grommets. Reseal if water is getting in.
• If a lamp is dead, check the fuse labelled TAIL/STOP and the bulb, then clean the holder contacts. A dab of dielectric grease helps prevent corrosion.

Swapping a bulb is a simple DIY job: open the tailgate, remove the trim/fixing screws, ease out the lamp unit, twist the bulb holder, and replace with the correct spec globe. Avoid mixing colours or wattages, and be cautious with LED conversions—only use ADR/E-mark compliant items to keep the vehicle road-legal and the beam pattern correct. If the circuit is intermittent, look for loose earth points in the rear quarter and repair corroded terminals.

For owners who tow, check the trailer plug wiring and ensure it doesn’t back-feed or overload the Gran Move’s circuits, a basic tow module goes a long way to protect the loom. Keep the lenses clean, the wiring tidy, and the correct bulbs in place, and the Gran Move’s tail-lights will quietly get on with the job, rain or shine.

What bulb types fit the 1999 Gran Move tail-lights?

The rear combination lamp commonly takes a dual-filament globe for stop/tail and single-filament globes for indicators and reverse. Exact specs can vary by market, so it’s best to confirm in the owner’s handbook or by checking the existing bulb bases and wattage stamps. Taking the old bulb to the parts counter also avoids mix-ups.

Are LED tail-light bulbs legal on a 1999 Gran Move in Australia or New Zealand?

They can be, but only if the replacement LEDs are compliant and suitable for the housing. Australian Design Rules and NZ Vehicle Lighting rules expect correct colour, brightness and light distribution. Use ADR/E-mark compliant LEDs designed for reflector housings, and ensure they don’t trigger fast-flash or warnings. If unsure, stick with quality halogen/incandescent globes that match the factory spec.

Why are my Gran Move tail-lights dim or intermittent?

Common culprits include old bulbs, corroded bulb holders, poor earth connections, and moisture inside the lamp. Start by replacing the bulbs, cleaning contacts, and checking the earth point in the rear quarter. If the issue persists, inspect the lamp seal and the TAIL/STOP fuse, and test for voltage drop with the lights on.