Your Selected Vehicle
Parts for your 1998 Suzuki Swift-Headlight bulbs
LED Autolamps 12/24V Front End Outline Marker Recessed Fitting Twin Blister - 7922WM2
LED Autolamps Twin function front position with supplementary front indicator - 97WIMCSB
Explore 4WD & Adventure
LED Autolamps Twin function rear position with supplementary rear indicator - 97RIMB
LED Autolamps Twin function front position with supplementary front indicator - 97WIMB
LED Autolamps 12/24V Side Marker Amber Lens Coloured LEDs Stainless Steel Bezel - 86AAM
LED Autolamps Rear End Outline LED Marker Red 12/24v Red Lens 16cm Cable Blister Pack - 42RM
LED Autolamps 12/24V Amber Marker Clear Lens Coloured LEDs Stainless Steel Bezel - 86AM
LED Autolamps Stop/Tail/Indicator Diffused Tail Function With Sequential Indicator - 520ARRMB
LED Autolamps MultiVolt R.H.S Stop/Tail/Indicator Assembly 128 Round LEDs - 125BARMR
LED Autolamps Multi Volt Stop/Tail/Indicator/Reverse Lamp 97 LEDs With Black Bracket - 200BARWM
LED Autolamps Traffic Advisory Light Green LED 12v Only Green Lens 10cm Cable Boxed - 83G
LED Autolamps Multi Volt Reverse Lamp With 35 SMDS Blister Pack With Black Base - 135WM
1998 Suzuki Swift headlight-bulbs — what they do and how to look after them
Headlight-bulbs are absolutely relevant to the 1998 Suzuki Swift. Technical references including the 1998 Suzuki Swift (SF series) owner’s manual and the Suzuki Genuine Parts catalogue specify a replaceable H4 12V 60/55W halogen bulb for the headlamps. Industry bulb guides from major lighting manufacturers also list H4 for this model across AU/NZ variants, confirming it’s a standard halogen reflector setup rather than a sealed-beam or HID unit.
On a ’98 Swift, the headlight-bulbs provide both low and high beam via a dual‑filament H4, giving clear forward vision at night and helping oncoming traffic see the car. Because halogen output fades with age, even before a filament blows, keeping bulbs fresh is a simple way to boost safety and stay compliant with local roadworthy/WOF checks.
For servicing, it’s smart to replace headlight-bulbs in pairs so beam colour and brightness match. Stick with 12V 60/55W H4 to avoid cooking wiring or reflectors, higher‑wattage bulbs can overheat and may not be legal without upgraded looms and relays. If extra punch is needed, choose ADR/ECE‑approved “plus” performance H4s rather than upping wattage.
Typical replacement steps are straightforward: unplug the three‑pin connector at the rear of the lamp, peel back the rubber boot, release the spring clip, remove the old H4, and seat the new bulb with the locating tab correctly oriented. Avoid touching the glass, fingerprints can create hot spots and shorten life. Reseat the clip, refit the boot, and reconnect the plug, then test both beams.
During a service, it’s worth checking aim and lens condition. Cloudy lenses or moisture inside the housing will dull output, polish the lens if it’s hazed and sort any seal leaks. If a new bulb doesn’t light, check the fuse, relay, and earth connections at the headlamp. Many owners do a quick headlight check every few months or before long night drives.
- Bulb spec: H4 (HB2/9003 equivalent), 12V 60/55W halogen
- Replace in pairs for even light and colour
- Don’t touch the glass, use gloves or a clean tissue
- Verify beam aim after any bulb change
FAQs
What bulb type fits a 1998 Suzuki Swift?
Most AU/NZ 1998 Swifts take an H4 12V 60/55W halogen bulb for both low and high beam. Trim levels and aftermarket headlamp assemblies can vary, so it’s wise to check the stamping on the headlamp or the owner’s manual before buying. Avoid higher‑wattage bulbs unless the wiring has been upgraded and the setup remains road‑legal.
How do you change the headlight-bulb on a ’98 Swift?
Open the bonnet, unplug the 3‑pin connector from the back of the headlamp, peel off the rubber dust boot, then unclip the spring retainer. Swap in the new H4 (don’t touch the glass), refit the clip and boot, reconnect the plug, and test low/high beam. If the beam pattern looks off, adjust the aim using the headlamp adjusters.
Should headlight-bulbs be replaced in pairs?
Yes, it’s recommended. Halogen bulbs dim over time, so a single fresh bulb can look brighter and a different colour to the older side. Replacing both keeps light output even and avoids one side failing soon after the other.