Your Selected Vehicle
Parts for your 1998 Nissan Primera-Headlight bulbs
LED Autolamps 12V Stop/Tail/Indicator Lamp With Reflex Reflector 100x100x25mm - 100BAR
LED Autolamps Rear End Outline LED Marker Red 12/24v Red Lens 16cm Cable Blister Pack - 42RM
LED Autolamps Twin function front position with supplementary front indicator - 97CWIMB
LED Autolamps Multi Volt Indicator Lamp With Clear Lens And Chrome Reflector Blister Pack - 131CAM
LED Autolamps Twin Function Stalk Side Indicator With Red/Amber Side Marker LHS Multivolt - 805ARIML
LED Autolamps 12/24V Reverse Light 200x50mm With 25 LEDs Black Bracket - 200BWM
Explore 4WD & Adventure
LED Autolamps 12/24V Rear Indicator Light With Amber Lens Blister Pack - 113AMG
LED Autolamps Twin function front position with supplementary front indicator - 97CWIM
LED Autolamps 12/24V Rear Indicator Lamp Red Reflector Blister Pack - 460AM
LED Autolamps Red LED Stop/Tail Lamp Insert For J3 Series Blister Pack - J3RM
LED Autolamps Amber LED Indicator Lamp Insert For J3 Series Blister Pack - J3AM
LED Autolamps Twin function side indicator with amber/red side marker - 97ARIM
LED Autolamps Twin function rear position with supplementary rear indicator - 97RIMB
LED Autolamps 10/30V Chrome Series LED Red Amber Side Marker With 40cm Wire - 35CCARM
LED Autolamps Twin function side indicator with amber/red side marker - 97CARIM
1998 Nissan Primera headlight-bulbs: what they do and how to look after them
Referencing the Nissan Primera (P11, 1996–1999) owner’s manual, the factory service manual, OE parts catalogues and major bulb makers’ fitment guides, the 1998 Nissan Primera is fitted with replaceable halogen headlight-bulbs. Most AU/NZ-market cars use a halogen setup, commonly an H4 60/55W dual‑filament for low/high in a single globe, while some trims with twin-lamp housings run separate low and high beams (typically H7 low and H1 high). Always confirm in the handbook or on the back of the lamp cover before ordering.
These headlight-bulbs provide the car’s primary forward lighting for night driving and poor weather. As halogens age, they dim and shift colour, so fresh globes can noticeably improve visibility. Sticking with the correct wattage is important for wiring, reflectors and compliance with local rules.
For routine servicing of a 1998 Primera’s headlight-bulbs, it’s smart to replace in pairs to keep light output even left to right. Avoid touching the glass with bare fingers, oils create hot spots that shorten life. After any bulb change, check the beam aim on level ground. If the car has manual headlight levelling, confirm the dial works and matches the load in the boot.
- When to replace: dim, yellowed light, intermittent output, “one side brighter”, visible darkening of the glass, or after 2–4 years of use even if not failed.
- Quick swap steps (typical halogen fit): ignition off, open the bonnet, remove the rubber dust cap, unplug the connector, release the spring clip, swap the headlight-bulb, align the tabs, refit the clip and cap, then test. The passenger side can be fiddlier, take your time.
- Good practice: inspect connectors for heat damage, clean earth points, keep lenses clear of haze, and never up-rate wattage beyond spec. If considering LED retrofits, check ADR/WoF legality and glare risk—most halogen housings aren’t designed for LED emitters.
- Service interval tip: include a headlight check every 10,000–15,000 km or at each oil service—output, aim, lens clarity and dust caps seated.
Keeping the Primera’s headlight-bulbs fresh and correctly aimed helps with safe night driving and keeps it right for roadworthy checks across Australia and New Zealand.
What bulb type fits a 1998 Nissan Primera?
Most P11 cars take an H4 60/55W dual‑filament globe. Some variants with separate low and high beams use H7 (low) and H1 (high). Check the owner’s manual or the marking on the rear of the headlamp for certainty.
Can they upgrade to LED headlight-bulbs?
LED retrofits in halogen housings can cause glare and may not comply with ADRs in Australia or WoF rules in NZ unless the entire lamp is approved for LED. If upgrading, use a compliant, tested assembly or stick with quality halogen bulbs for legal, consistent beam focus.
Why are the headlights still dim after new globes?
Common culprits are cloudy lenses, voltage drop from aged wiring or poor earths, or misaligned beams. Try restoring the lens, checking connectors and grounds, and verifying alternator output. Correcting these often brings the brightness back.