Your Selected Vehicle
Parts for your 1998 Nissan Primera-Headlight bulbs
LED Autolamps LHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284LHS
LED Autolamps 24V Front Direction Indicator With Front Position Lamp Chrome Bracket - 200CAW/24
LED Autolamps 12/24V Cat6 Side Direction Indicator Clear Lens Blister Pack - 77ACM
LED Autolamps Twin function side indicator with amber/red side marker - 97CARIMCSB
Explore 4WD & Adventure
LED Autolamps Front Marker LED White With Reflector 12-24V Perm Mnt - EU38WMHD
LED Autolamps Tray Conversion Kit To suits Hilux Contains Two Cables - PATCH-HILUX
LED Autolamps 174 Series Reverse Lamp 12/24V, Surface Mount, 40cm Cable - 174WMB
LED Autolamps 174 Series Stop/Tail/Indicator Lamp 12/24V, Surface Mount, 40cm Cable - 174ARMB
LED Autolamps 12/24V Round Stop/Tail Lamp With Clear Lens 130mm Diameter Recessed Mount Blister Pack - 102RCM
LED Autolamps Twin function rear position with supplementary rear indicator - 97RIM
LED Autolamps 12V Stop/Tail/Indicator/Licence Plate Lamp With Reflector - 149BARL4P
LED Autolamps 12/24 Multi Volt Stop/Tail Lamp 36 LEDs With 40cm Wire - 80RM
LED Autolamps Multi Volt Stop/Tail Lamp With Rubber Grommet And Plug - 164RM
LED Autolamps 12V Stop/Tail/Indicator Lamp Reflector With 4 Pin Plug - 149BAR4P
LED Autolamps Licence Plate Lamp Black Bracket Multi Volt With 1m Cable - 35BLM1P
1998 Nissan Primera headlight-bulbs: what they do and how to look after them
Referencing the Nissan Primera (P11, 1996–1999) owner’s manual, the factory service manual, OE parts catalogues and major bulb makers’ fitment guides, the 1998 Nissan Primera is fitted with replaceable halogen headlight-bulbs. Most AU/NZ-market cars use a halogen setup, commonly an H4 60/55W dual‑filament for low/high in a single globe, while some trims with twin-lamp housings run separate low and high beams (typically H7 low and H1 high). Always confirm in the handbook or on the back of the lamp cover before ordering.
These headlight-bulbs provide the car’s primary forward lighting for night driving and poor weather. As halogens age, they dim and shift colour, so fresh globes can noticeably improve visibility. Sticking with the correct wattage is important for wiring, reflectors and compliance with local rules.
For routine servicing of a 1998 Primera’s headlight-bulbs, it’s smart to replace in pairs to keep light output even left to right. Avoid touching the glass with bare fingers, oils create hot spots that shorten life. After any bulb change, check the beam aim on level ground. If the car has manual headlight levelling, confirm the dial works and matches the load in the boot.
- When to replace: dim, yellowed light, intermittent output, “one side brighter”, visible darkening of the glass, or after 2–4 years of use even if not failed.
- Quick swap steps (typical halogen fit): ignition off, open the bonnet, remove the rubber dust cap, unplug the connector, release the spring clip, swap the headlight-bulb, align the tabs, refit the clip and cap, then test. The passenger side can be fiddlier, take your time.
- Good practice: inspect connectors for heat damage, clean earth points, keep lenses clear of haze, and never up-rate wattage beyond spec. If considering LED retrofits, check ADR/WoF legality and glare risk—most halogen housings aren’t designed for LED emitters.
- Service interval tip: include a headlight check every 10,000–15,000 km or at each oil service—output, aim, lens clarity and dust caps seated.
Keeping the Primera’s headlight-bulbs fresh and correctly aimed helps with safe night driving and keeps it right for roadworthy checks across Australia and New Zealand.
What bulb type fits a 1998 Nissan Primera?
Most P11 cars take an H4 60/55W dual‑filament globe. Some variants with separate low and high beams use H7 (low) and H1 (high). Check the owner’s manual or the marking on the rear of the headlamp for certainty.
Can they upgrade to LED headlight-bulbs?
LED retrofits in halogen housings can cause glare and may not comply with ADRs in Australia or WoF rules in NZ unless the entire lamp is approved for LED. If upgrading, use a compliant, tested assembly or stick with quality halogen bulbs for legal, consistent beam focus.
Why are the headlights still dim after new globes?
Common culprits are cloudy lenses, voltage drop from aged wiring or poor earths, or misaligned beams. Try restoring the lens, checking connectors and grounds, and verifying alternator output. Correcting these often brings the brightness back.