Parts for your 1997 Nissan Pulsar-Temperature sensors

1997 Nissan Pulsar (N15) temperature-sensors: what they do and when to replace them

Temperature-sensors are absolutely fitted to the 1997 Nissan Pulsar (N15) and are essential to how it runs. The Nissan N15 Factory Service Manual (EC and EL sections, 1996–1999) details the Engine Coolant Temperature (ECT) sensor feeding the ECU, a separate single‑wire sender for the dash gauge, and ECU-controlled radiator fans that switch based on ECT input. Gregory’s Nissan Pulsar N14/N15 Service & Repair Manual and the Haynes Almera (N15) manual back this up and list resistance checks for these thermistor-type sensors. Many GA16DE and SR20DE Pulsars also use an Intake Air Temperature (IAT) sensor (often integrated with the airflow meter) for fine-tuning fuel and spark.

On an N15, the temperature-sensors let the ECU know how hot the engine and incoming air are, so it can adjust fuelling, ignition timing, idle speed, and when to kick the cooling fans on. The dash sender keeps the gauge honest under the bonnet. When one of these sensors drifts out of spec, the Pulsar can be hard to start cold, idle too high, run rich, chew through fuel, or show a dodgy gauge reading. The ECU may log codes and show a coolant temp that doesn’t match reality on a scan tool.

As part of regular servicing, there’s no fixed kilometre interval to replace the ECT or IAT, but they should be tested if there are drivability niggles, unexplained fan behaviour, or odd gauge readings. A quick check with a scan tool for live coolant temp and an ohmmeter test against manual specs (for example, a healthy Nissan ECT thermistor typically measures a few kΩ at 20°C and a few hundred Ω at 80–90°C—always verify with the N15 manual) will tell the story.

Replacement on the Pulsar is straightforward with basic spanners: cool the engine, relieve pressure, unplug, swap the sensor, and top up/bleed the coolant. Use a new sealing washer or approved thread sealant if specified, and tighten to the factory torque (commonly in the 18–25 N·m range—check the N15 FSM for your engine). After fitting, bleed out air, verify fan cut‑in, and confirm the gauge and scan tool temps agree. For IATs housed in the airflow meter, keep the intake clean and the air filter fresh