Parts for your 1997 Mitsubishi Lancer-Oil seals

1997 Mitsubishi Lancer oil seals — what they do and when to replace them

Oil seals are absolutely fitted to the 1997 Mitsubishi Lancer. Technical sources such as the Mitsubishi Lancer (CK/CE) factory workshop manual (1995–2003) specify inspection and replacement procedures for crankshaft front and rear oil seals, camshaft seals, and transaxle/driveshaft oil seals. The Mitsubishi ASA electronic parts catalogue and common aftermarket manuals (e.g., Haynes for Lancer 1992–2005) also list these seals as service parts for this model. So, oil seals are very much relevant to the 1997 Lancer’s engine and driveline.

On this Lancer, oil seals keep lubricants where they belong and grit out of harm’s way. They sit around rotating shafts and at key housings to prevent engine oil and gearbox oil escaping under the bonnet and under the car. When they harden or wear, the tell-tale signs are oily weeps, drips on the driveway, the smell of burning oil, or a slipping, contaminated timing belt.

• Engine: crankshaft front (behind the crank pulley), crankshaft rear (rear main, at the gearbox side), and camshaft seals (behind the timing cover).
• Transmission: input shaft seal, output/driveshaft seals at each CV, and selector shaft seals (varies by transaxle).

For good measure, many owners plan seal replacement around other jobs. Front crank and cam seals are often renewed during timing belt and water pump service intervals (typically every 100,000–105,000 km or time-based). It’s smart practice because access is already open and the incremental parts cost is low. The rear main seal is commonly tackled when the clutch is out on manual cars, as the gearbox must be removed for access.

Symptoms worth a closer look include oil misting inside the timing cover, fresh oil at the bellhousing join, or gearbox oil around the inner CVs. Left alone, leaks can soak a timing belt, shorten alternator life, or drop gearbox oil to unsafe levels. Replacement involves carefully prying the old seal, checking crank/cam surfaces, and installing the new seal square with light oil on the lip