Your Selected Vehicle
Parts for your 1997 Daihatsu Terios-Headlights
LED Autolamps Multi Volt Stop/Tail/Indicator With 18 Square LEDs Twin Blister - 135ARM/2
LED Autolamps Multi Volt Stop/Tail/Indicator/Reverse Lamp 97 LEDs With Black Bracket - 200BARWM
Explore 4WD & Adventure
LED Autolamps Front End Outline Marker White 12/24Vwith 2P plugs 10cm cable - 58WMB2P
LED Autolamps Twin function side indicator with amber/red side marker - 97ARIMB
LED Autolamps 12V LED Stop/Tail/Indicator/Reverse Assemnly Lamp With 108 LEDs - 80BARW
LED Autolamps 12/24V Round Indicator Lamp With Clear Lens 130mm Diameter Recessed Mount - 102ACM
LED Autolamps 10/30V Front Outline Position Marker 4 White LEDs With 40cm Wire - 35WM
LED Autolamps 12/24V Stop/Tail Lamp With Reflector 14 LEDs Blister Package - 130RMG
LED Autolamps Multi Volt LED Licence Plate Lamp With Chrome Base Twin Blister - 30CLM
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly 3 Lamps With 153 LEDs - 125BARWM
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly With 123 LEDs - 100BARWM
LED Autolamps Twin function rear position with supplementary rear indicator - 97RIMB
LED Autolamps Twin Function Stalk Side Indicator With Red/Amber Side Marker LHS Multivolt - 805ARIML
LED Autolamps MultiVolt R.H.S Stop/Tail/Indicator Assembly 128 Round LEDs - 125BARMR
LED Autolamps 12V Stop/Tail/Indicator/Reverse Assembly Chrome Bracket Blister Pack - 82CARRW
1997 Daihatsu Terios Headlights
Headlights are absolutely fitted to the 1997 Daihatsu Terios and are essential equipment. This is supported by the Daihatsu Terios J100-series owner’s/workshop literature for the late-1990s models, which specifies halogen headlamps, and by period Australian Design Rules such as ADR 13/00 covering the installation of lighting devices on passenger vehicles. In short, the Terios was built to run with conventional halogen headlights from factory.
On this compact 4x4, the headlights do the heavy lifting for safe night driving, country-road visibility, and being seen by others in bad weather. The factory setup uses reflector-style halogen lamps, commonly taking an H4 dual‑filament bulb (often 12V 60/55W). Actual bulb spec can vary with market, so it’s smart to confirm against the glovebox handbook or a trusted parts catalogue for the vehicle’s VIN. Good lamps help the Terios cut through drizzle, foggy mornings and unlit rural lanes without blinding oncoming traffic.
As part of routine servicing, it’s worth giving the headlights a quick once-over. Replace bulbs in pairs so beam colour and brightness match. If lenses have gone yellow or cloudy, a quality restoration kit can bring them back. Check connectors for heat damage, make sure the rubber dust boots are intact, and keep fingerprints off the glass when installing new bulbs—skin oils can shorten bulb life. A light smear of dielectric grease on connectors helps keep moisture at bay, handy in Kiwi and Aussie conditions.
- Switch off, let lamps cool, and disconnect the negative battery terminal.
- From the engine bay, unplug the headlamp connector and peel back the rubber dust boot.
- Release the spring clip, remove the old bulb, and fit the new H4 with the tabs correctly aligned. Don’t touch the glass.
- Refit the clip and boot, reconnect the plug, then test low and high beam.
- Check headlight aim against a wall and tweak the adjusters if needed to avoid dazzling others.
For aiming, park on level ground about 5 metres from a flat wall, measure headlight height at the car, and set the low‑beam cut-off a little below that mark. If the aim adjusters feel seized, a small turn and some care goes a long way—don’t force them.
Popular questions about 1997 Daihatsu Terios headlights
What headlight bulb does a 1997 Terios use?
Most 1997 Terios (J100 series) use an H4 dual‑filament halogen bulb, typically 12V 60/55W. Always double‑check the handbook or parts lookup for your exact trim and market before buying.
How often should headlight bulbs be replaced?
There’s no fixed interval, but halogen bulbs dim over time. Many owners swap them every 2–4 years or at the first sign of a dim, yellowed beam. Replace in pairs to keep light output even.
How do you adjust the headlight aim?
Use the vertical and horizontal adjust screws at the back of each headlamp. Park on level ground facing a wall, set the cut‑off just below headlamp height at about 5 m, and make small adjustments so low beam doesn’t dazzle oncoming traffic.