Your Selected Vehicle
Parts for your 1997 Daihatsu Terios-Headlights
LED Autolamps 24V Front Direction Indicator With Front Position Lamp Chrome Bracket - 200CAW/24
LED Autolamps 12/24V Cat6 Side Direction Indicator Clear Lens Blister Pack - 77ACM
LED Autolamps Twin function side indicator with amber/red side marker - 97CARIMCSB
LED Autolamps Front Marker LED White With Reflector 12-24V Perm Mnt - EU38WMHD
Explore 4WD & Adventure
LED Autolamps Tray Conversion Kit To suits Hilux Contains Two Cables - PATCH-HILUX
LED Autolamps 174 Series Reverse Lamp 12/24V, Surface Mount, 40cm Cable - 174WMB
LED Autolamps 174 Series Stop/Tail/Indicator Lamp 12/24V, Surface Mount, 40cm Cable - 174ARMB
LED Autolamps 12/24V Round Stop/Tail Lamp With Clear Lens 130mm Diameter Recessed Mount Blister Pack - 102RCM
LED Autolamps Twin function rear position with supplementary rear indicator - 97RIM
LED Autolamps 12V Stop/Tail/Indicator/Licence Plate Lamp With Reflector - 149BARL4P
LED Autolamps 12/24 Multi Volt Stop/Tail Lamp 36 LEDs With 40cm Wire - 80RM
LED Autolamps Multi Volt Stop/Tail Lamp With Rubber Grommet And Plug - 164RM
LED Autolamps 12V Stop/Tail/Indicator Lamp Reflector With 4 Pin Plug - 149BAR4P
LED Autolamps Licence Plate Lamp Black Bracket Multi Volt With 1m Cable - 35BLM1P
LED Autolamps 12V 82 Series Stop/Tail/Indicator/Reverse Lamp Black Bracket - 82BARW
1997 Daihatsu Terios Headlights
Headlights are absolutely fitted to the 1997 Daihatsu Terios and are essential equipment. This is supported by the Daihatsu Terios J100-series owner’s/workshop literature for the late-1990s models, which specifies halogen headlamps, and by period Australian Design Rules such as ADR 13/00 covering the installation of lighting devices on passenger vehicles. In short, the Terios was built to run with conventional halogen headlights from factory.
On this compact 4x4, the headlights do the heavy lifting for safe night driving, country-road visibility, and being seen by others in bad weather. The factory setup uses reflector-style halogen lamps, commonly taking an H4 dual‑filament bulb (often 12V 60/55W). Actual bulb spec can vary with market, so it’s smart to confirm against the glovebox handbook or a trusted parts catalogue for the vehicle’s VIN. Good lamps help the Terios cut through drizzle, foggy mornings and unlit rural lanes without blinding oncoming traffic.
As part of routine servicing, it’s worth giving the headlights a quick once-over. Replace bulbs in pairs so beam colour and brightness match. If lenses have gone yellow or cloudy, a quality restoration kit can bring them back. Check connectors for heat damage, make sure the rubber dust boots are intact, and keep fingerprints off the glass when installing new bulbs—skin oils can shorten bulb life. A light smear of dielectric grease on connectors helps keep moisture at bay, handy in Kiwi and Aussie conditions.
- Switch off, let lamps cool, and disconnect the negative battery terminal.
- From the engine bay, unplug the headlamp connector and peel back the rubber dust boot.
- Release the spring clip, remove the old bulb, and fit the new H4 with the tabs correctly aligned. Don’t touch the glass.
- Refit the clip and boot, reconnect the plug, then test low and high beam.
- Check headlight aim against a wall and tweak the adjusters if needed to avoid dazzling others.
For aiming, park on level ground about 5 metres from a flat wall, measure headlight height at the car, and set the low‑beam cut-off a little below that mark. If the aim adjusters feel seized, a small turn and some care goes a long way—don’t force them.
Popular questions about 1997 Daihatsu Terios headlights
What headlight bulb does a 1997 Terios use?
Most 1997 Terios (J100 series) use an H4 dual‑filament halogen bulb, typically 12V 60/55W. Always double‑check the handbook or parts lookup for your exact trim and market before buying.
How often should headlight bulbs be replaced?
There’s no fixed interval, but halogen bulbs dim over time. Many owners swap them every 2–4 years or at the first sign of a dim, yellowed beam. Replace in pairs to keep light output even.
How do you adjust the headlight aim?
Use the vertical and horizontal adjust screws at the back of each headlamp. Park on level ground facing a wall, set the cut‑off just below headlamp height at about 5 m, and make small adjustments so low beam doesn’t dazzle oncoming traffic.