Your Selected Vehicle
Parts for your 1995 Suzuki Swift-Headlight bulbs
LED Autolamps Multi Volt Stop/Tail/Indicator Lamp With Reflex Reflectors Grey Base Blister Pack 1 pce - 100ARM
LED Autolamps 174 Series Stop/Tail/Indicator Lamp 12/24V, Surface Mount, 40cm Cable - 174ARMB
Explore 4WD & Adventure
LED Autolamps 174 Series Reverse Lamp 12/24V, Surface Mount, 40cm Cable - 174WMB
LED Autolamps 174 Series Stop/Tail Lamp 12/24V, Surface Mount, 40cm Cable - 174RMB
LED Autolamps 12V Stop/Tail Lamp Black Chrome Round With Clear Lens - 102RBC
LED Autolamps 10/30V LED Side Direction Indicator Light With 30cm Wire - 35AMB
LED Autolamps 12/24V Round Stop/Tail Lamp With Clear Lens 130mm Diameter Recessed Mount Blister Pack - 102RCM
LED Autolamps Licence Plate Lamp Black Bracket Multi Volt With 1m Cable - 35BLM1P
LED Autolamps 12V Front Indicator Amber Lens Black Base Twin Blister Pack - 175A/2
LED Autolamps LHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284LHS
LED Autolamps 12/24V Reversing Lamp With 25 White LEDs With Bracket and 30cm Wire - 100WM
LED Autolamps 12V 82 Series Stop/Tail/Indicator/Reverse Lamp Black Bracket - 82BARW
LED Autolamps 12/24 Multi Volt Stop/Tail/Indicator/Reverse Assembly Lamp With 108 LEDs - 80BARWM
LED Autolamps 12/24V LED Reverse Lamp Screw Surface Mount Blister Pack - 12WM-2
LED Autolamps Multi Volt Stop/Tail/Indicator With 18 Square LEDs Twin Blister - 135ARM/2
1995 Suzuki Swift headlight bulbs
Headlight bulbs are absolutely relevant to the 1995 Suzuki Swift. Technical references including the Suzuki Swift SF-series workshop manual, the 1995 owner’s handbook, and major bulb application catalogues from Philips/Osram specify a replaceable halogen H4 (12V 60/55W) dual‑filament bulb for each headlamp. That means the Swift uses a standard, serviceable bulb rather than a sealed-beam or factory LED unit.
On a ’95 Swift, the headlight bulb’s job is simple but crucial: throw a clean, legal beam pattern for low and high beam so night driving stays safe and compliance-friendly. The H4 bulb houses two filaments, handling both dipped and main beam in the same globe. Over time, halogen bulbs fade, the light colour shifts more yellow, and output drops, even before a filament finally pops. That’s why proactive replacement is smart, especially if the car does a lot of night kilometres.
Best practice is to replace headlight bulbs in pairs to keep the colour and brightness even from side to side. Use quality, ADR/UN ECE‑approved H4 60/55W bulbs to stay legal in Australia and New Zealand. LED “retrofit” bulbs in a halogen housing are generally not road-legal unless the entire lamp is certified for them, otherwise they can fail a WoF/RWC check and cause glare.
DIY replacement on the Swift is straightforward under the bonnet: unplug the 3‑pin connector, peel back the rubber boot, release the spring clip, swap the globe, and refit everything in reverse. Don’t touch the glass—skin oils create hot spots that shorten bulb life. After fitting, check beam aim on a flat surface, if a lens looks cloudy or there’s moisture inside, sort the seal or lens condition so the new bulbs can perform properly.
During regular servicing, a quick lighting check pays off. Look for dimness, flicker, or a pinkish tinge (a sign a filament is near the end). Inspect the connectors for heat discolouration, ensure the earths are clean, and keep the headlamp lenses clear of road grime. Many owners opt for “long‑life” H4s for durability, or “plus output” halogens for a brighter but still legal upgrade—just stick to the correct wattage.
- Bulb type: H4, 12V 60/55W halogen (dual filament)
- Replace in pairs, avoid touching glass
- Confirm legality before considering LED conversions
What headlight bulb does a 1995 Suzuki Swift use?
Most 1995 Swifts take an H4 12V 60/55W halogen bulb with a P43t base. Variants and market differences are rare, but it’s worth checking the owner’s handbook, the marking on the headlamp cover, or a trusted parts catalogue by VIN to be sure.
Can LED bulbs be fitted to a 1995 Swift for road use in AU/NZ?
Generally no, unless the entire headlamp assembly and the LED light source are certified to the relevant ADR/UN ECE standards. Retrofit LEDs in halogen reflectors often cause glare and can fail WoF/RWC. Keep LEDs for off‑road unless you have certified components.
Why replace headlight bulbs in pairs?
Halogens dim with age. If only one side is new, the beam pattern and colour won’t match, which can affect visibility and annoy oncoming traffic. Pair replacement gives balanced light and reduces the chance of the other side failing soon after.