Your Selected Vehicle
Parts for your 1994 Suzuki Jimny-Headlight bulbs
LED Autolamps 12/24 Multi Volt Stop/Tail/Indicator/Reverse Assembly Lamp With 108 LEDs - 80BARWM
LED Autolamps Multi Volt Stop/Tail/Indicator/Reverse Lamp 97 LEDs With Black Bracket - 200BARWM
LED Autolamps 12/24V Reversing Lamp With 25 White LEDs With Bracket and 30cm Wire - 100WM
LED Autolamps Front Marker LED White With Reflector 12-24V Perm Mnt - EU38WMHD
Explore 4WD & Adventure
LED Autolamps 10/30V Front Outline Position Marker 4 White LEDs With 40cm Wire - 35WM
LED Autolamps 12V Stop/Tail/Indicator/Reverse Assembly Chrome Bracket Blister Pack - 82CARRW
LED Autolamps Front End Outline Marker White 12/24Vwith 2P plugs 10cm cable - 58WMB2P
LED Autolamps 12/24V Round Indicator Lamp With Clear Lens 130mm Diameter Recessed Mount - 102ACM
LED Autolamps MultiVolt R.H.S Stop/Tail/Indicator Assembly 128 Round LEDs - 125BARMR
LED Autolamps Twin function side indicator with amber/red side marker - 97ARIMB
LED Autolamps 12V LED Stop/Tail/Indicator/Reverse Assemnly Lamp With 108 LEDs - 80BARW
LED Autolamps Twin function rear position with supplementary rear indicator - 97RIMB
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly With 123 LEDs - 100BARWM
LED Autolamps Multi Volt LED Licence Plate Lamp With Chrome Base Twin Blister - 30CLM
LED Autolamps RHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284RHS
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly 3 Lamps With 153 LEDs - 125BARWM
LED Autolamps 12/24V LED Stop/Tail/Indicator Light 284x100x27mm Blister Pack - 282ARRM
LED Autolamps Twin function rear position with supplementary rear indicator - 97CRIM
LED Autolamps Twin function front position with supplementary front indicator - 97WIM
1994 Suzuki Jimny Headlight Bulbs
Headlight bulbs are absolutely used on the 1994 Suzuki Jimny. Technical sources including the Suzuki Jimny (JA11) owner’s manual and Suzuki’s Electronic Parts Catalogue specify an H4 halogen globe (12V, 60/55W) for the headlamps on early-’90s Jimny models. Independent application guides from lighting manufacturers common in Australia and New Zealand (such as Narva and Hella) also list H4 for 1990–1995 Jimny/JA11 vehicles. On that basis, headlight-bulbs are relevant to this model and are a normal service item.
On a ’94 Jimny, the headlight bulbs do the heavy lifting for safe night driving, providing low beam for general road use and high beam for open-road visibility. Good globes help the Jimny meet ADR/WOF requirements and keep glare under control for oncoming traffic.
As part of routine servicing, it’s smart to check the beam pattern, lens clarity, and brightness. If one globe fails, replace both sides together to keep colour and output matched. Stick with the specified H4 12V 60/55W rating, going higher wattage without upgraded relays and wiring can overheat connectors and reflectors.
- Switch the lights off, open the bonnet, and unplug the 3‑pin H4 connector from the rear of the lamp.
- Peel back the rubber dust boot, unclip the spring retainer, and remove the old globe.
- Avoid touching the new bulb’s glass, if you do, clean it with isopropyl alcohol.
- Seat the H4 correctly (tabs aligned), refit the spring, boot, and connector.
- Test low/high beam, then check and adjust aim on a level surface if needed.
If the lights look dim or yellowed, consider quality +30%/+50% halogen H4 options rather than high-wattage units. Also check for voltage drop at the headlamp plugs and clean earth points—older wiring and corroded connectors are common culprits. Cloudy lenses or tired reflectors reduce output too, replacing housings can restore performance.
Thinking about LED retrofits? Many drop-in LEDs aren’t compliant in halogen reflectors and can fail ADR/WOF inspections or cause glare. If upgrading, use road-legal solutions matched to approved housings, or keep LEDs for off‑road use.
For touring, carrying a spare H4 and some fuses is cheap insurance. Replacing a globe on the Jimny is a quick driveway job with basic tools and a steady hand.
- What headlight bulb fits a 1994 Suzuki Jimny?
A standard H4 halogen globe, 12V 60/55W. That’s what Suzuki specifies for the JA11-era Jimny. Stick with reputable brands and avoid higher-wattage bulbs unless the wiring and relays have been professionally upgraded. - Are LED headlight bulbs legal in a 1994 Jimny?
In Australia and New Zealand, most LED “retrofit” globes in halogen reflector housings aren’t road-legal and may fail WOF/roadworthy. Use approved halogen H4s, or if going LED, choose a certified headlamp assembly designed for LED and compliant with local standards. - Why are my Jimny’s headlights dim?
Ageing halogen bulbs, corroded connectors, weak earths, and cloudy lenses are usual suspects. Start with fresh H4 globes, clean the plugs and grounds, check charging voltage, and ensure the beam aim is correct. Consider new lamp housings if reflectors are dull.