Your Selected Vehicle
Parts for your 1994 Nissan Primera-Headlight bulbs
Explore 4WD & Adventure
Narva Heavy Duty Rocker Switch Momentary On/Off/Momentary On DPDT (Contacts Rated 20A @ 12V) - 63044BL
Narva Push Button Starter Switch On/Off Momentary SPST Red LED (Contacts Rated 50A @ 12V) - 60099BL
Narva Sealed Rocker Switch Off/On SPDT 12V Blue Illuminated Backup Lights Symbol (Contacts Rated 20A @ 12V) - 63142BL
1994 Nissan Primera headlight bulbs — fitment, purpose, and easy service tips
Technical sources confirm the 1994 Nissan Primera (P10) uses replaceable halogen headlight bulbs, not sealed-beam units. The Nissan Primera P10 Owner’s Manual and Factory Service Manual specify H4 60/55 W dual‑filament bulbs for most trims, and well‑regarded bulb catalogues (e.g., Osram and Philips) list H4 for 1994 Primera applications, with some variants using separate bulbs for fogs (often H3). The Haynes Service and Repair Manual for Nissan Primera (1990–1999) also details headlamp bulb replacement on the P10. So yes—headlight bulbs are absolutely relevant for this model.
On a 1994 Primera, the headlight bulbs do the heavy lifting for safe night driving and foul weather. The common H4 halogen setup handles both low and high beam via a dual filament, working with the reflector to throw a clean, ADR-friendly beam pattern. When bulbs age, they dim and shift colour, which makes night driving tougher and can cop a WoF or rego fail.
Servicing headlight bulbs on this car is straightforward. Access is from the engine bay: unplug the connector, peel back the rubber dust boot, release the spring clip, and the bulb pulls out. Slot the new bulb in the same orientation, refit the clip and boot, and reconnect. Don’t touch the glass—oils from fingers can hot‑spot the quartz. Gloves or a clean tissue do the trick.
- Always replace bulbs in pairs so the beam colour and brightness match.
- Stick to the correct wattage (typically 60/55 W H4) to avoid wiring or reflector damage.
- After fitting, check headlight aim and adjust if needed to prevent glare.
- Inspect the dust boot and connector for cracks or corrosion