Your Selected Vehicle
Parts for your 1993 Toyota Hilux surf-Headlights
LED Autolamps LHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284LHS
LED Autolamps 12V Front Indicator Amber Lens Black Base Twin Blister Pack - 175A/2
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Lamp 460x130x33mm - 460ARWM
LED Autolamps 24V Front Direction Indicator With Front Position Lamp Chrome Bracket - 200CAW/24
Explore 4WD & Adventure
LED Autolamps Front Marker LED White With Reflector 12-24V Perm Mnt - EU38WMHD
LED Autolamps 174 Series Reverse Lamp 12/24V, Surface Mount, 40cm Cable - 174WMB
LED Autolamps 174 Series Stop/Tail/Indicator Lamp 12/24V, Surface Mount, 40cm Cable - 174ARMB
LED Autolamps Tray Conversion Kit To suits Hilux Contains Two Cables - PATCH-HILUX
LED Autolamps Multi Volt Stop/Tail Lamp With Rubber Grommet And Plug - 164RM
LED Autolamps 12/24 Multi Volt Stop/Tail Lamp 36 LEDs With 40cm Wire - 80RM
LED Autolamps 12/24V Round Stop/Tail Lamp With Clear Lens 130mm Diameter Recessed Mount Blister Pack - 102RCM
LED Autolamps 12V Stop/Tail/Indicator/Licence Plate Lamp With Reflector - 149BARL4P
LED Autolamps 12V Stop/Tail/Indicator Lamp Reflector With 4 Pin Plug - 149BAR4P
LED Autolamps Twin function rear position with supplementary rear indicator - 97RIM
LED Autolamps Licence Plate Lamp Black Bracket Multi Volt With 1m Cable - 35BLM1P
1993 Toyota Hilux Surf Headlights
Headlights are absolutely relevant to, and factory-fitted on, the 1993 Toyota Hilux Surf (N130 series). This is confirmed by Toyota’s Owner’s Manual and Repair Manual for the Hilux Surf/4Runner of the era, and by roadworthiness rules such as Australia’s ADR 13/00 and ADR 46/00 and New Zealand’s Vehicle Lighting Rule, which require compliant headlamps for on-road use. In short: the ’93 Surf rolled out with headlamps and can’t be legally driven at night without them.
On most 1993 Surf models the headlamp units are halogen reflector types running an H4 dual‑filament bulb (typically 60/55 W). Their job is simple but critical: dipped beam gives a clean cutoff to light the lane without dazzling others, and high beam throws long-range light for open‑road visibility. Good, correctly aimed headlights reduce fatigue, improve reaction time, and keep the vehicle compliant for WOF/rego checks.
For replacement and upkeep, a bit of routine attention goes a long way:
- Replace bulbs in pairs so brightness and colour match.
- Stick to the specified H4 wattage, over‑wattage bulbs can cook wiring and reflectors.
- Keep lenses clean, bug grime and road film seriously cut light output.
- Check aim after any front‑end work or bulb change.
- Inspect for moisture inside the housing, renew seals or vents if there’s fogging.
Typical bulb swap steps: disconnect the battery negative, pull off the rear connector and rubber boot, unclip the spring retainer, swap the H4 bulb without touching the glass, clip back in, refit boot and connector. Test both beams, then park on level ground about 5–10 metres from a wall to tweak aim using the adjusters so the dipped cutoff sits just below head height and kicks up slightly to the left (for AU/NZ RHD spec) without dazzling.
Many ’93 Surf units use glass lenses, which resist UV haze, if yours has aftermarket plastic lenses, consider a restoration kit if they’ve gone cloudy. If a lamp is cracked or reflectors are dull, replace the assembly—light output won’t recover with a bulb alone.
Thinking about LEDs? Only use ADR/ECE‑approved complete headlamp units or certified LED H4 replacements where legal, non‑approved retrofits can fail WOF/rego and may glare oncoming traffic. For peace of mind, follow the Toyota manuals for the N130 Surf and stick with quality, compliant parts.
What headlight bulb does a 1993 Hilux Surf use?
Most 1993 Hilux Surf models take an H4 dual‑filament halogen bulb rated 60/55 W. Some imported or modified vehicles may differ, so it’s smart to check the owner’s manual or the markings on the lamp housing before buying bulbs.
How do you adjust headlight aim on a 1993 Hilux Surf?
Use the vertical and horizontal adjusters on the back of each lamp. Park 5–10 metres from a wall on level ground, set tyre pressures and normal load, then align the dipped beam so the cutoff is just below head height and slightly up to the left for RHD. Small turns make big changes—go slowly and test drive at night.
Are LED headlight upgrades legal for this model in Australia or NZ?
They’re only legal if the complete headlamp assembly or replacement light source is approved to the relevant ADR/ECE standard and correctly aimed. Many drop‑in LED H4 bulbs aren’t compliant and can fail WOF/rego or cause glare. If upgrading, choose certified units and have the aim checked.