Your Selected Vehicle
Parts for your 1993 Suzuki Swift-Headlight bulbs
LED Autolamps Multi Volt Stop/Tail/Indicator Lamp With Reflex Reflectors Grey Base Blister Pack 1 pce - 100ARM
LED Autolamps 174 Series Stop/Tail/Indicator Lamp 12/24V, Surface Mount, 40cm Cable - 174ARMB
Explore 4WD & Adventure
LED Autolamps 174 Series Reverse Lamp 12/24V, Surface Mount, 40cm Cable - 174WMB
LED Autolamps 174 Series Stop/Tail Lamp 12/24V, Surface Mount, 40cm Cable - 174RMB
LED Autolamps 12V Stop/Tail Lamp Black Chrome Round With Clear Lens - 102RBC
LED Autolamps 10/30V LED Side Direction Indicator Light With 30cm Wire - 35AMB
LED Autolamps 12/24V Round Stop/Tail Lamp With Clear Lens 130mm Diameter Recessed Mount Blister Pack - 102RCM
LED Autolamps Licence Plate Lamp Black Bracket Multi Volt With 1m Cable - 35BLM1P
LED Autolamps 12V Front Indicator Amber Lens Black Base Twin Blister Pack - 175A/2
LED Autolamps LHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284LHS
LED Autolamps 12/24V Reversing Lamp With 25 White LEDs With Bracket and 30cm Wire - 100WM
LED Autolamps 12V 82 Series Stop/Tail/Indicator/Reverse Lamp Black Bracket - 82BARW
LED Autolamps 12/24 Multi Volt Stop/Tail/Indicator/Reverse Assembly Lamp With 108 LEDs - 80BARWM
LED Autolamps 12/24V LED Reverse Lamp Screw Surface Mount Blister Pack - 12WM-2
LED Autolamps Multi Volt Stop/Tail/Indicator With 18 Square LEDs Twin Blister - 135ARM/2
1993 Suzuki Swift headlight bulbs
Headlight bulbs absolutely are used on the 1993 Suzuki Swift. Technical references including the Suzuki SF/413 workshop manual, Suzuki electronic parts catalogue, and AU/NZ bulb guides from brands like Narva and Philips list a replaceable halogen H4 (60/55W) globe for this model’s headlamps. That means it’s not a sealed-beam unit, the bulb can be changed separately from the headlight housing.
On a ’93 Swift, the headlight bulbs do the heavy lifting for safe night and wet-weather driving, providing both low and high beam from a dual‑filament H4 globe. Keeping them fresh maintains good visibility, helps the car pass WOF/regos, and avoids that uneven “one dim, one bright” look. Because halogens gradually lose output with age, it’s smart to replace in pairs so beam colour and brightness match.
As part of routine servicing, a quick headlight check goes a long way. Look for dull or yellowed light, flicker, or a blown high/low beam. Inspect the connectors for heat discolouration and make sure the headlight lenses are clean and clear. Stick with quality 12V H4 60/55W globes to meet ADR/NZ requirements—going higher wattage without upgraded wiring and relays can cook switches and looms.
DIY replacement is straightforward on most 1993 Swift variants:
- Switch off the car and let the lamps cool. Pop the bonnet.
- Unplug the 3‑pin connector from the back of the headlamp.
- Peel off the rubber dust boot.
- Unclip the spring retainer and remove the old bulb.
- Install the new H4 bulb, aligning the locating tabs. Don’t touch the glass—use gloves.
- Refit the clip, boot, and connector, then test both beams.
- Check aim against a wall and adjust the headlight screws if needed, as per the manual.
Handy tips: replace bulbs in pairs, add a light smear of dielectric grease to the connector, keep a spare globe in the glovebox, and avoid LED or higher‑watt halogen conversions unless they’re specifically approved and road‑legal for your car and jurisdiction.
- Typical bulb: H4 halogen, 60/55W
- Service note: No fixed interval—expect 2–5 years depending on use and vibration
- Legal note: Use ADR/NZ‑compliant bulbs for road use
Popular questions about 1993 Suzuki Swift headlight bulbs
What bulb type fits a 1993 Suzuki Swift?
Most AU/NZ‑spec 1993 Swifts take an H4 halogen 60/55W dual‑filament globe. Variants can differ by market and trim, so it’s worth checking the owner’s handbook or the existing bulb markings. If someone’s retrofitted headlights from another market, verify the connector and bulb base before buying.
Why are my Swift’s headlights dim even after new bulbs?
Common culprits are cloudy lenses, poor earths, tired connectors, or voltage drop in older wiring. Clean the lenses, check the headlight fuse/relays and grounds, and measure voltage at the bulb with lights on. A quality, legal‑spec bulb plus healthy wiring typically restores brightness.
Can I upgrade to LED bulbs?
LED retrofit bulbs in halogen reflector housings may not be road‑legal and can cause glare if not approved. If considering LEDs, confirm they’re compliant for your state or NZ WOF rules and that the beam pattern remains correct. For hassle‑free legality and performance, a premium H4 halogen is a safe bet.