Parts for your 1992 Nissan Primera-Oil seals

1992 Nissan Primera oil-seals — purpose, servicing and replacement

Based on technical sources, oil-seals are absolutely fitted to the 1992 Nissan Primera (P10). The Nissan Primera P10 Factory Service Manual (Engine Mechanical and Transaxle/Automatic Transmission sections) details procedures for front and rear crankshaft oil-seals, camshaft oil-seals and transaxle output shaft seals. The Nissan FAST electronic parts catalogue and major OEM catalogues (e.g., NOK/Corteco listings for P10 with GA16DE, SR20DE and CD20 engines) also specify multiple engine and driveline oil-seals for this model. So oil-seals are relevant, common and critical to keeping fluids where they should be.

On a 1992 Primera, oil-seals keep engine oil and gearbox oil from sneaking past spinning shafts and out onto the driveway. They ride on the crank and cams up front and at the rear main, and they sit at the driveshaft outputs on the gearbox. When they harden or wear, you’ll see drips, smell hot oil, or notice low oil levels.

• Common seals on the P10: front crank seal (in the oil pump/timing cover), rear main seal, camshaft oil-seals, distributor/CAS O-ring (engine-dependent), and manual/auto transaxle driveshaft/output seals.

They’re not a routine “replace by kilometres” item, but they’re smart to do while you’re in there. For GA16DE and CD20 timing-belt engines, replace the front crank and cam seals during a belt service. For SR20DE timing-chain cars, replace front crank and cam seals when there’s access or if seepage shows up. Rear main seals are typically done with a clutch job or when the gearbox is out.

• Tell-tale signs: oil mist around the crank pulley or timing cover, drops at the bellhousing, clutch slip from oil contamination, or gear oil weeping where the CV shafts meet the ‘box.

1. Confirm the source before replacing—clean, UV dye if needed, and re-check.
2. Use quality seals (Viton/NOK-spec) and inspect the shaft surface for grooves