Parts for your 1992 Nissan Primera-Brake pads

1992 Nissan Primera (P10) brake pads: what they do and how to look after them

Yes, brake pads are absolutely used on the 1992 Nissan Primera (P10). Technical references including the Nissan Primera P10 Factory Service Manual (Brake/BR section), the Haynes Nissan Primera 1990–1999 service manual, and reputable parts catalogues from Bendix/Bosch list front disc brakes with pads across the range, with rears being either solid discs with pads on higher trims or drum brakes with shoes on certain variants. So, brake pads are directly relevant to the front axle on every 1992 Primera, and to the rear axle on models fitted with rear discs.

On this era of Primera, the pads clamp onto the brake rotors to convert the car’s kinetic energy into heat. Good pads deliver consistent pedal feel, shorter stopping distances, and quieter, more predictable braking in Aussie and Kiwi conditions—think stop–start city traffic, long country drives, and the odd hilly descent.

For servicing, it’s smart to inspect pads every 10,000 km or six months. Replace when friction material is down to about 3 mm, if a wear indicator squeals, or if the car pulls under braking. Whenever pads are changed, check rotor thickness against the stamped minimum, look for heat spots or scoring, and replace or machine rotors if needed. Fresh pad hardware and clean, freely moving slider pins (with the correct high-temp lubricant on pins only) help prevent uneven wear and squeal.

Choosing pads comes down to use: ceramic or low-metallic pads are quiet and low dust for daily driving, while quality semi-metallic pads handle spirited runs and heavier loads better. Avoid bargain-bin compounds