Your Selected Vehicle
Parts for your 1991 Suzuki Vitara-Headlight bulbs
LED Autolamps Front End Outline Marker White 12/24Vwith 2P plugs 10cm cable - 58WMB2P
LED Autolamps Twin function side indicator with amber/red side marker - 97ARIMB
LED Autolamps 12V LED Stop/Tail/Indicator/Reverse Assemnly Lamp With 108 LEDs - 80BARW
LED Autolamps 12/24V Round Indicator Lamp With Clear Lens 130mm Diameter Recessed Mount - 102ACM
Explore 4WD & Adventure
LED Autolamps 10/30V Front Outline Position Marker 4 White LEDs With 40cm Wire - 35WM
LED Autolamps 12/24V Stop/Tail Lamp With Reflector 14 LEDs Blister Package - 130RMG
LED Autolamps Multi Volt LED Licence Plate Lamp With Chrome Base Twin Blister - 30CLM
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly 3 Lamps With 153 LEDs - 125BARWM
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly With 123 LEDs - 100BARWM
LED Autolamps Twin function rear position with supplementary rear indicator - 97RIMB
LED Autolamps Twin Function Stalk Side Indicator With Red/Amber Side Marker LHS Multivolt - 805ARIML
LED Autolamps MultiVolt R.H.S Stop/Tail/Indicator Assembly 128 Round LEDs - 125BARMR
LED Autolamps 12V Stop/Tail/Indicator/Reverse Assembly Chrome Bracket Blister Pack - 82CARRW
LED Autolamps Twin function rear position with supplementary rear indicator - 97CRIM
LED Autolamps Twin function front position with supplementary front indicator - 97WIM
LED Autolamps 12/24V LED Stop/Tail/Indicator Light 284x100x27mm Blister Pack - 282ARRM
LED Autolamps RHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284RHS
LED Autolamps Front Marker LED White With Reflector 12-24V Perm Mnt - EU38WMHD
1991 Suzuki Vitara headlight bulbs
Headlight bulbs are absolutely relevant on the 1991 Suzuki Vitara. Factory documentation and bulb catalogues confirm the headlamps take a replaceable halogen H4 (also known as 9003/HB2) dual‑filament globe, 60/55W. This is backed by the Suzuki Vitara workshop manual (lighting section, first‑gen models) and fitment guides from major globe makers commonly used in Australia and New Zealand. So, not sealed beams—just a standard H4 globe that handles both low and high beam inside each headlamp unit.
On a ’91 Vitara, the headlight bulbs do the heavy lifting for safe night and poor‑weather driving. The H4 globe’s two filaments give a dipped beam for oncoming traffic and a main beam for open‑road visibility. When they fade or fail, drivers cop dim output, patchy spread, and eye‑strain, not to mention a likely WOF or rego knock‑back. Keeping the globes fresh and the lenses clear is a simple way to stay legal and safe, whether it’s weekday commuting or a weekend run to the beach.
As part of regular servicing, it’s worth:
- Replacing headlight globes in pairs to keep colour and brightness even.
- Avoiding touching the glass, use gloves or a clean tissue to prevent hot spots on halogen bulbs.
- Inspecting the connector for heat damage and the rubber dust boot for a good seal.
- Cleaning lens exteriors and restoring any UV‑hazed plastic for better light output.
- Checking headlight aim after any bulb or suspension work to avoid glare and dark patches.
- Sticking with 60/55W unless a relay loom and legal requirements are met for higher wattage.
Replacement is straightforward: unclip the rubber dust boot behind the headlamp, release the spring clip, unplug the old H4, then seat the new globe with the locating tabs correctly aligned. Refit the clip, plug and boot, then test both beams. A dab of dielectric grease on the connector can help ward off corrosion, especially on older wiring looms.
Thinking about upgrades? Quality “+” performance halogen H4s can boost brightness without extra load. LED retrofit bulbs may not be ADR/NZS compliant in a halogen housing for road use and can cause glare if not designed for the reflector—always check local rules and product approvals before fitting.
What headlight bulb fits a 1991 Suzuki Vitara?
An H4 (HB2/9003) 60/55W halogen globe fits the low and high beam in each headlamp. It’s a dual‑filament globe, widely available across Australia and New Zealand from major brands. Always match the socket and wattage shown in the owner’s or workshop manual.
Can I swap to LED or higher‑wattage bulbs?
Many LED retrofit bulbs aren’t approved for on‑road use in AU/NZ when installed in halogen reflectors, and they can create glare. If you want more light legally, choose premium halogen H4s. Higher‑wattage halogens need a relay loom and are typically for off‑road use only—check ADR/NZS rules before changing.
How often should I replace the bulbs?
Halogens dim over time, so replace in pairs every few years or when you notice yellowing, flicker, or uneven beam. If the lights still seem weak after new globes, check lens clarity, aim, and the condition of the connectors and earths.