Your Selected Vehicle
Parts for your 1990 Suzuki Jimny-Headlights
LED Autolamps Multi Volt Stop/Tail/Indicator/Reverse Lamp 97 LEDs With Black Bracket - 200BARWM
Explore 4WD & Adventure
LED Autolamps Front End Outline Marker White 12/24Vwith 2P plugs 10cm cable - 58WMB2P
LED Autolamps Twin function side indicator with amber/red side marker - 97ARIMB
LED Autolamps 12V LED Stop/Tail/Indicator/Reverse Assemnly Lamp With 108 LEDs - 80BARW
LED Autolamps 12/24V Round Indicator Lamp With Clear Lens 130mm Diameter Recessed Mount - 102ACM
LED Autolamps 10/30V Front Outline Position Marker 4 White LEDs With 40cm Wire - 35WM
LED Autolamps 12/24V Stop/Tail Lamp With Reflector 14 LEDs Blister Package - 130RMG
LED Autolamps Multi Volt LED Licence Plate Lamp With Chrome Base Twin Blister - 30CLM
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly 3 Lamps With 153 LEDs - 125BARWM
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly With 123 LEDs - 100BARWM
LED Autolamps Twin function rear position with supplementary rear indicator - 97RIMB
LED Autolamps Twin Function Stalk Side Indicator With Red/Amber Side Marker LHS Multivolt - 805ARIML
LED Autolamps MultiVolt R.H.S Stop/Tail/Indicator Assembly 128 Round LEDs - 125BARMR
LED Autolamps 12V Stop/Tail/Indicator/Reverse Assembly Chrome Bracket Blister Pack - 82CARRW
LED Autolamps Twin function rear position with supplementary rear indicator - 97CRIM
LED Autolamps Twin function front position with supplementary front indicator - 97WIM
1990 Suzuki Jimny Headlights
Headlights are absolutely fitted to the 1990 Suzuki Jimny. Factory service manuals and period parts catalogues for the late-’80s to early-’90s Jimny/Sierra (SJ413/JA11) specify round halogen headlamps with H4 bulbs, complete with relays, fuses and aiming hardware. That aligns with Australian and New Zealand road standards of the era, which require operational low and high beams from the factory.
On a rugged little 4x4 like the 1990 Jimny, headlights do more than tick a legal box. They light up bush tracks after dark, help spot washouts in drizzle, and make the vehicle visible to others on misty mornings. The standard setup is a pair of 7-inch round housings taking 60/55W H4 bulbs in most markets, with some variants using sealed-beam units. Either way, clear lenses, sound wiring and correct aim make a big difference to night-time confidence.
As part of regular servicing, owners should give the headlights a quick once-over. Look for yellowing, crazing, or moisture inside the lens, check the connectors for heat damage, and confirm both beams fire cleanly without flicker. Dim output often points to tired bulbs, corroded earths, or voltage drop in the original wiring. A relay upgrade can sharpen brightness without jumping to over-wattage globes.
Replacing a bulb is straightforward on most 1990 Jimnys that use H4 capsules:
- Switch off and disconnect the battery negative.
- Remove the bezel and retaining ring, then ease the lamp forward.
- Unplug the 3-pin connector and spring clip, swap the bulb, and avoid touching the glass.
- Refit the clip, connector, lamp and ring, then test low/high beam.
If the vehicle has sealed beams, replace the entire lamp unit. After any work, check aim against a flat wall: low beam should dip slightly and the left cut-off should sit below oncoming eye height. Aim screws are on the bucket, a small screwdriver and patience go a long way.
Upgrades are tempting, but stick with quality ADR/E-marked lamps or bulbs. Over-wattage globes can cook factory switches unless relays and wiring are uprated. Keep the lenses clean, ensure good earths, and a 1990 Jimny will punch well above its weight after dark.
Popular questions
What bulb type does a 1990 Suzuki Jimny use?
Most 1990 Jimny/Sierra models take a standard H4 60/55W halogen. Some trims or markets used 7-inch sealed-beam units, which require swapping the full lamp rather than just the bulb. A quick look behind the bezel will confirm which version is fitted.
How do you adjust the headlight aim on a 1990 Jimny?
Use the adjuster screws on each headlight bucket. Park on level ground facing a wall about 3–5 metres away, set tyre pressures and vehicle load, then tweak vertical and horizontal screws so low beam dips slightly and doesn’t dazzle oncoming traffic.
Why are my Jimny’s headlights dim or flickering?
Common causes are ageing bulbs, corroded connectors or earths, and voltage drop through old wiring. Clean the contacts, check the fuses and relays, and consider a headlight relay harness to deliver full battery voltage to the lamps.