Parts for your 1990 Nissan Primera-Wiper blades

1990 Nissan Primera (P10) Wiper Blades — Fitment, Purpose, and Care

Wiper blades are absolutely fitted to the 1990 Nissan Primera (P10). Technical references including the Nissan Primera P10 owner’s manual and factory service manual, the Nissan FAST electronic parts catalogue, and major aftermarket application guides (e.g., Bosch and Trico) all list front windscreen wiper blades for the P10, with a rear wiper blade specified on hatch and some wagon variants. That confirms wiper blades are relevant and used on this model.

On a 1990 Nissan Primera, the wiper blades do the simple but vital job of keeping the windscreen clear so the driver can see what’s coming. In Aussie and Kiwi conditions—sun, salty air, and sudden showers—rubber squeegees cop a hiding. Fresh blades sweep away rain, mist, road film, and bug splatter, cutting glare and eye strain, and helping the car pass a WOF or rego inspection without drama.

Most P10 sedans and hatches use a conventional hook-type arm, typically taking around 550 mm (22") on the driver’s side and 500 mm (20") on the passenger’s side. Hatch and wagon models commonly have a rear blade of about 400 mm (16"), while sedans generally do without a rear wiper. Fitment can vary by market and trim, so it’s smart to check the owner’s manual or measure what’s on the car before ordering.

As part of routine servicing, wiper blades deserve a quick once-over. A clean windscreen helps too—dust and grit chew through the rubber. Top up the washer bottle with proper screenwash (not just plain water), and run the washers to lubricate the first few sweeps. If the arms feel weak or chatter across the glass, check spring tension and hinge freedom, and replace the arm or blade assembly if needed.

• Replace every 6–12 months, sooner in harsh sun or coastal areas.
• Swap them if there’s streaking, squeaking, juddering, or cracked edges.
• Wipe the blade edge with a damp cloth and mild detergent at each service.
• Don’t run wipers on a dry screen, lift blades off the glass in frost or when parked long-term in hot sun.

When buying, match the length and the connector (the P10 typically uses a 9x3 or 9x4 mm hook). Premium beam blades reduce wind lift at highway speeds, while budget conventional frames work fine if replaced on schedule.

Popular questions

What wiper blade sizes fit a 1990 Nissan Primera (P10)?
Most P10s take about 550 mm (driver) and 500 mm (passenger). Hatch and wagon models usually have a rear around 400 mm. Always confirm by checking the manual or measuring the existing blades and noting the hook connector.

How often should wiper blades be replaced on a 1990 Primera?
Every 6–12 months is a good rule for Australia and New Zealand. If you see streaks, hear squeaks, get glare in rain, or notice splits in the rubber, replace sooner.

How do you change the wiper blades on a P10?
Lift the arm, press the small tab on the hook adapter, slide the old blade off, then slide the new blade in until it clicks. Protect the glass with a cloth while the arm is raised, and test with washer fluid after fitting.