Your Selected Vehicle
Parts for your 1989 Suzuki Jimny-Batteries
LED Autolamps 12/24V Reversing Lamp With 25 White LEDs With Bracket and 30cm Wire - 100WM
LED Autolamps Multi Volt Stop/Tail/Indicator With 18 Square LEDs Twin Blister - 135ARM/2
LED Autolamps Multi Volt Stop/Tail/Indicator/Reverse Lamp 97 LEDs With Black Bracket - 200BARWM
Explore 4WD & Adventure
LED Autolamps 12/24 Multi Volt Stop/Tail/Indicator/Reverse Assembly Lamp With 108 LEDs - 80BARWM
LED Autolamps 12V LED Stop/Tail/Indicator/Reverse Assemnly Lamp With 108 LEDs - 80BARW
LED Autolamps 12/24V LED Stop/Tail/Indicator Light 284x100x27mm Blister Pack - 282ARRM
LED Autolamps Twin function front position with supplementary front indicator - 97WIM
LED Autolamps Front End Outline Marker White 12/24Vwith 2P plugs 10cm cable - 58WMB2P
LED Autolamps MultiVolt R.H.S Stop/Tail/Indicator Assembly 128 Round LEDs - 125BARMR
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly 3 Lamps With 153 LEDs - 125BARWM
LED Autolamps RHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284RHS
LED Autolamps Twin function rear position with supplementary rear indicator - 97CRIM
LED Autolamps 12V Stop/Tail/Indicator/Reverse Assembly Chrome Bracket Blister Pack - 82CARRW
LED Autolamps Twin function side indicator with amber/red side marker - 97ARIMB
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly With 123 LEDs - 100BARWM
1989 Suzuki Jimny Batteries – what they do and how to look after them
Technical sources confirm a 12‑volt starting battery is absolutely fitted to and required by the 1989 Suzuki Jimny. The Suzuki SJ413/Samurai factory service manual (Electrical – Charging & Starting), the late‑1980s Suzuki Jimny/SJ413 owner’s handbook (12 V negative‑earth system, battery maintenance), and the Haynes Repair Manual for Suzuki Samurai/SJ413 (1986–1995) all describe the battery, starter and alternator setup on this model.
On a 1989 Jimny, the battery’s job is straightforward: deliver a big burst of current to crank the G‑series petrol engine, stabilise voltage for lights and electrics, and buffer the alternator while driving. Even with a carburetted setup and minimal electronics, the battery is the heart of reliable cold starts, night driving, and off‑road accessories.
For everyday servicing, a few simple checks go a long way:
- Visual condition – look for cracked cases, swelling, or loose hold‑downs. Corrugations and trails can work clamps loose, so keep it snug without over‑tightening.
- Terminals – clean corrosion with a bicarb‑and‑water solution, rinse, dry, and finish with a light smear of dielectric grease. Ensure clamps are firm.
- Electrolyte (if serviceable/flooded type) – plates must be covered, top up with distilled water only.
- State of charge – engine off: about 12.6 V is healthy, 12.2 V is getting low. Engine running: 13.8–14.5 V typically indicates the alternator and regulator are doing their job.
Replacement is simple and worth doing proactively every 3–5 years, sooner if the Jimny sees short trips or rough work. Choose a 12 V lead‑acid SLI battery that fits the tray and matches terminal orientation. A cold‑cranking rating in the 330–500 CCA range suits most Aussie and Kiwi conditions, if running a winch, fridge or lights, consider an AGM upgrade or a dual‑battery system with an isolator.
- Save radio presets if needed, switch off, and pop the bonnet.
- Remove negative (–) first, then positive (+). Lift the old unit out carefully.
- Drop in the new battery, secure the hold‑down, and reconnect positive (+) then negative (–).
- Start the engine and confirm charging voltage. If it’s low or erratic, inspect the belt and alternator.
Signs it’s time to sort a new battery include lazy cranking, dim lights at idle, repeated jump‑starts, a sulphur smell, or a case that’s hot after a drive. A quick load test during a service will head off surprises when the weather turns.
Popular questions about 1989 Suzuki Jimny batteries
What battery type and size suits a 1989 Suzuki Jimny?
The 1989 Jimny uses a 12 V lead‑acid starting battery. Pick a unit that physically fits the factory tray and matches terminal orientation. For most climates, a mid‑range battery with roughly 330–500 CCA works well. If the vehicle runs extra accessories, an AGM of the same size can offer better vibration resistance and reserve capacity.
How long should the battery last?
Typically 3–5 years in Australia and New Zealand. Heat, short trips, corrugations, and winching shorten life. Watch for slow cranking, needing a jump after sitting, swollen cases, or low resting voltage even after a proper charge—these are all cues to replace it.
What charging voltage should they see?
With the engine running and accessories off, expect about 13.8–14.5 V at the battery posts. Much below 13.5 V can point to belt, alternator, or regulator issues, consistently over 15.0 V risks overcharging and battery damage.